Toilet Paper Holder Replacement

Geschrieben von: Elizabeth Opheim
  • Kommentare: 1
Toilet Paper Holder Replacement

Schwierigkeitsgrad

Moderate

Schritte

4

Zeitaufwand

Keine Schätzung

Einleitung

Over time, the screws and brackets securing a toilet paper holder can loosen or become disconnected entirely. This guide will walk you through the steps of replacing a broken or loose toilet paper holder.

  1. 2cI1nYj1Q1uOQOdy
    2cI1nYj1Q1uOQOdy
    AXdhHAdMCdPkt4lk
    ULDA1C4PPKqrhiBJ

    • Unscrew the four screws of the original broken holder.

    • You may want to wear gloves.

    • If there is damage to the wall behind the old holder, check out the iFixit guide for repairing a hole in drywall.

  2. oFG6sPhNmYRbKXGY
    oFG6sPhNmYRbKXGY
    U4cZIYDH6lbWjQVa
    cA3RVcrFUrCFGVRO

    • Measuring the area where you want your new holder to go, mark two lines 6.8" apart.

    • Measure an inch and a third (1 and 1/3") above the marks and mark these new spots where your screws will go.

    • While marking where you want to place the new holder, use a leveling tool to make sure that the toilet paper will be sitting flat.

  3. oYPugrTpCNSSetEy
    oYPugrTpCNSSetEy
    K2VnqywWHuiQFsyH
    XuxMh6gTMVBTb5LX

    • Place the new screw inside the new bracket and line up the mark with the base of the screw.

    • Make sure that the indentation for the toilet paper holder is facing in.

    • Repeat this for the top and bottom screws on both the left and right bracket bases (4 times total).

  4. sgTQqgkOdT3Bywxf
    sgTQqgkOdT3Bywxf
    vHJSTTW6YPY6eJy5
    KwcVROURKaJv2qNy

    • Insert the spring loaded toilet roll bar and enjoy.

Abschluss

Hopefully you have enjoyed exploring this repair guide and now understand how to repair and replace a broken toilet paper roll holder.

Tinte & Feder

Elizabeth Opheim

Mitglied seit: 19/01/16

121 Reputation

Ein Kommentar

I don’t like the spring loaded holders. When we moved into our new house two years ago, One of the spring loaded holders was too far apart. Another was two close so roll would not rotate. The other two were ok. I replaced 3 of the 4 with the single arm holder. No need to fiddle with spring loaded holders. Slip on and slip off. Did the same at our previous house. I now have 3 spring loaded holders that I will donate or throw away.

Pete

Pete Chisteckoff -