TomTom VIA 1530 TM Back Replacement

Geschrieben von: Jennifer Zakaria

Kommentare: 0

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

10 Minuten

Einleitung

The back is either connected or interfaced with most components of the device. Since this must be removed in order to reach other interior components of the device, this guide will show how to remove it properly.

Werkzeuge

Schritt 1

Position the device so that the underside is facing up.
Tilt the EasyPort Mount slightly upward and rotate it counterclockwise 180 degrees from the initial position.
Firmly grab the EasyPort Mount and remove it.
If it does not dislodge easily, gently twist the EasyPort Mount, applying increasing pressure until it does.

Schritt 2

Turn the device 180 degrees so the screw in the EasyPort Mount compartment is on top.
Remove the 2mm screw beneath the EasyPort Mount compartment with the Torx T-5 head Screwdriver.

Schritt 3

Flip the device over so that the screen is facing up.
Wedge the plastic opening tool between the top and bottom of the device's frame, gently sliding it around the outside edge.
It may be easier to start at one of the corners.
The gold ribbon cable connecting the screen to the motherboard is fragile and tears easily.
This specific device's ribbon cable is torn.

Schritt 4

Carefully slide the screen forward, revealing the lower portion of the motherboard.
Remove the 3.6mm screw using the JIS #00 Screwdriver.
Rotate the device 180 degrees, carefully slide back the screen, and remove the remaining two screws.