Top Cover Removal

Geschrieben von: Sam Gustafson
  • Kommentare: 0
Top Cover Removal

Schwierigkeitsgrad

Difficult

Schritte

10

Zeitaufwand

10 Minuten

Einleitung

This guide shows how to remove the top cover of the Pentax MZ-S. Removing the top panel is often the starting point of more in depth repairs.

  1. nrFIAZKufxVD3cQS

    • Push down the latch to release the film door.

  2. WmaqIpCbXyXjfaFK
    WmaqIpCbXyXjfaFK
    3MNFDKVuEm6fkKQJ
    FSUvVvV2KMcpaLoq

    • Remove two 7.5 mm #00 screws.

    • Remove one 9.0 mm #00 screw.

    • Remove one 13.5 mm #00 screw from inside the battery compartment.

  3. ARErbhLaDZLsHNur
    ARErbhLaDZLsHNur
    KRYoT2GRAmLhMIyX
    Si1BeE1GrR5KKWJm

    • Push the button to pop up the flash.

    • Remove one 3.5 mm #00 screw.

    • Remove one 5.5 mm #00 screw.

  4. CTrkEcCILGrCXkJ2

    • Carefully lift the top cover away from the body to access wired connections.

    • The top cover is still connected in several locations.

  5. 1nkNeTyCiA24OyKN
    1nkNeTyCiA24OyKN
    NxBPcIppF4mVjLpj

    • Peel back the corner of the rubber grip.

    • Remove the small plastic cover.

    • Be careful not to short the wires before the flash capacitors have been properly discharged.

  6. tbrArotaUPgo2Ekq

    • Use a 1kΩ-10kΩ high power resistor to discharge the capacitor. Place the resistor between the blue wire, exposed in the previous step, and ground.

    • The flash capacitors store energy at a very high voltage. Failing to discharge the capacitors properly could result in personal injury and/or damage to the camera.

  7. YdycH1sEqaJCoOjL

    • Carefully lift the sides of the white latch.

    • Hold the flex PCB on the camera body in place as you lift to prevent damaging the flex.

  8. 3uAZsfEVbYVPPBmZ

    • Desolder the red wire.

    • Carefully lift the sides of the white latch.

    • Hold the flex PCB on the camera body in place as you lift to prevent damaging the flex.

  9. WyHHmqDh1UjeRCvX
    WyHHmqDh1UjeRCvX
    OCEScxHQboYDoSSH

    • Desolder blue, black, brown and green wires.

    • Remove the loose shim washer if present.

  10. bvJQ2WLlb5c4daYO
    bvJQ2WLlb5c4daYO
    EyLukSUjlvUJc6D3

    • Remove the piece of cellophane tape covering the flex connections.

    • Desolder flex connetions.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Sam Gustafson

Mitglied seit: 02/09/22

1920 Reputation

0 Kommentare