Einleitung

  1. MYSFFWfWbVMZeB5E
    • Make sure battery-lock is in the unlock position.

    • Slide button to the left.

  2. u2jbesioYZLwBx2Y
    • Lift battery out of the computer.

  3. 41hoNcclWcTCBiLw
    41hoNcclWcTCBiLw
    nKVTmGOl5LKx4qYM
    • Remove the two 5.62 mm screws from the optical drive cover.

  4. 1JTbXyO4wjDZAxSF
    1JTbXyO4wjDZAxSF
    SbknKattVw6F4KJY
    • Remove the optical drive cover.

    • A plastic opening tool or a fingernail may be helpful in lifting it from its groove.

  5. MdEG4hmRWUwbFlnZ
    • Using the inset divot, push the optical drive out of the laptop to remove.

  6. WhbAInQZ1OdZKJRK
    WhbAInQZ1OdZKJRK
    SZMV3V2AHb6DC6BK
    jhaOwUjZvim42e3L
    • Remove the 8.6 mm screw.

  7. XMyHTJuSFH1LnrwE
    XMyHTJuSFH1LnrwE
    lBJmKup3XkyZOpoj
    eyqt2nDiOb31h1nU
    • Push the bottom left corner of the CD Drive until the drive protrudes from the case.

    • When a good amount of the CD Drive is showing on the right side, gently pull it out completely.

  8. MFDyeJyY4oHGV3Ln
    MFDyeJyY4oHGV3Ln
    EUWyLk3XcKZrpbtq
    • Remove the 5.75 mm screw from the cover panel.

    • Turn the laptop over with the screen facing down.

  9. YbPKI3amQ1Rm3oxY
    • Lift up the cover panel using a plastic opening tool.

  10. REx5lH5ORy1WBGQq
    REx5lH5ORy1WBGQq
    63MvNZBRVZ15xqHB
    • Remove the 5.64 mm screw from the bottom of the crossing bar.

    • Remove the crossing bar.

  11. fih24ysSZyjpuKD6
    fih24ysSZyjpuKD6
    sXhPTGPbZBZEqnaH
    • Use a plastic opening tool to disconnect the black and white antenna cable's connectors from the Wi-Fi card.

    • Note that the black wire is connected to the port that is labeled main.

  12. N4ZXjcjKmM5ABD4I
    N4ZXjcjKmM5ABD4I
    LLtDcM2CY5JGsbwK
    • Use fingers to push the clips away from memory card.

  13. 3enlaghWVtFFlnTe
    • Use fingers to remove the Wi-Fi card.

  14. DQQEX5R3VuuuDSMZ
    DQQEX5R3VuuuDSMZ
    EovTqu6lhI1Rgf4q
    6tF1CaqUfNspD53Z
    • Use the plastic opening tool to lift up the top panel all the way along the keyboard until it loosens.

    • It may be helpful to first pry at the rear of the hinge covers (not shown) to release them. Then Insert the plastic opening tool underneath the top panel's sides and then front edge.

  15. E6SIqotbAmFpMvMI
    E6SIqotbAmFpMvMI
    XZLeTRFypmMKKJ11
    • Remove the top panel by popping the panel out the top left socket, then do the same with the right side.

  16. K1psOEBT6prn5Sq2
    K1psOEBT6prn5Sq2
    U6LHlWbTDchyYuA2
    2WNs1VrSr12Y4OLi
    • Remove the two 3.67 mm screws from the top corners of the keyboard.

  17. 4YOyaXMIHXdORCBJ
    • Use fingers to lift up the keyboard from the top.

    • Do not try to remove the keyboard completely because it is still attached to the motherboard.

  18. JheEhn56wNugpKTQ
    JheEhn56wNugpKTQ
    IYoDAWiqsxsEDaFr
    A3HQyJACuJ1i5WwM
    • Remove the cable connecting the keyboard with the motherboard.

    • Be aware of the locking tabs on each side of the ribbon-cable connector—they slide back about 2mm to free the cable.

    • Lift up and remove the keyboard.

  19. bPdSoOB3fgBYmTLs
    bPdSoOB3fgBYmTLs
    uOOMNFAcZHCLHW3J
    • Remove the 3.76mm screw from the ground wire.

  20. oINWjRvtrCdbB6KV
    oINWjRvtrCdbB6KV
    CCslGLhf1BDtVWSU
    • Use the plastic opening tool to remove the wire.

  21. L5NaMmFYPHxYIfUZ
    L5NaMmFYPHxYIfUZ
    FstkIihkQu43xEX1
    • Gently pull the black and white wires out of the upper case.

    • Do not pull the wire too much, or you can damage the wire.

  22. JRtjtJtdPxFmmwAW
    • Remove the 8.6 mm screw on left side of upper case.

  23. PoI2mSopCoZPVxWJ
    PoI2mSopCoZPVxWJ
    LZYAJCgBIcGDSNOG
    • Remove two 8.6 mm screws on the back corners of the laptop.

  24. 6c6tFRfGyEM3jrY2
    • Lift up the display assembly to remove it.

    one of the 14 screws identified in the diagram of step 25 was previously removed with the CD drive

    Steve -

  25. vFMXoQ2qSQcFOCIt
    vFMXoQ2qSQcFOCIt
    PBnUAOB6EbQKarET
    • Use the Phillips screwdriver to remove the two 3.7 mm screws from the battery compartment.

    • Then remove the fourteen 8.6 mm screws from the bottom of the case.

    There is one more not circled on the top left of this photo, left of the rubber foot.

    Barron Chung -

  26. OOhBOMqDsdZJ235n
    • Use the screwdriver to remove six 8.6 mm screws from the top of the case.

    On mine the leftmost screw here was 3mm.

    Barron Chung -

  27. wiFc4KoU1UXmvQeo
    wiFc4KoU1UXmvQeo
    oU6UVIEjOAKdvsqm
    • Use the plastic opening tool to remove the two speaker wire connectors and the trackpad connector from the motherboard.

  28. 4dST2KGcijD6ReUV
    • With the plastic opening tool, pry around the entire laptop to separate the upper case.

  29. VxCDIJIhqRHYZIcI
    • Lift up the upper case to remove.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Garrett Gudgel

Mitglied seit: 05/10/10

751 Reputation

0 Kommentare