Trek 820 Light Mount Replacement

Geschrieben von: Kaveh Karimiyanha
  • Kommentare: 0
Trek 820 Light Mount Replacement

Schwierigkeitsgrad

Easy

Schritte

5

Zeitaufwand

5 Minuten

Einleitung

You may need to replace the light mount on your bicycle because the light has burned out or you require a brighter light. This guide shows the proper steps to install a replacement Light Mount for a Trek 820 (or similar) bicycle. No tools are necessary for this easy repair.

Ersatzteile

  1. AiIuDOuwIdEluhnt
    AiIuDOuwIdEluhnt
    MLZqPTVkZeAklfX5

    • Clean the area where the light mount will be installed with a soft cloth.

    • Placing the light mount close to the center stem.

  2. bOA1mYyCZOcDMPrM

    • Remove the strap from the light mount fitting.

    • Stretch the strap clockwise around the handlebars.

  3. DlWAghciSICUWmJc

    • Slide the strap through the slot and fasten to a snug, but moveable fit.

    • Do not fasten too tight as this will make it difficult to fine tune light mount placement.

  4. RFcSWSITlShpqoVy

    • Pull the strap tightly through the clasps at the bottom of the mount.

  5. 2e22XwnyGod3sBlQ
    2e22XwnyGod3sBlQ
    I1LMDGKto4hrhAD2

    • Place the fastening screw in the rear screw port on the light mount.

    • Twist the screw clockwise using your hands until fully fastened.

Abschluss

Now you have a light mount ready for safer night rides on your Trek bicycle!

Tinte & Feder

Kaveh Karimiyanha

Mitglied seit: 24/09/12

807 Reputation

0 Kommentare