Uniden Dect 6.0 Display Replacement

Geschrieben von: Megan Lawrence

Kommentare: 6

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

5 Minuten

Einleitung

This guide shows you how to replace the display on a Uniden Dect 6.0 home phone. Use this guide if you have a poor quality display or no display at all on the phone’s LED screen.

Make sure the screen isn’t faulty due to the battery before moving on. Check the Uniden Dect 6.0 Troubleshooting page for more information.

Werkzeuge

Schritt 1

Locate the battery compartment on the back of the Uniden home phone.
Place your finger on the groove, and pull directly back on the cover to access to the battery.

the hand set does not work nither one will charge I just bought it from Walmart in sant cloud florida I have the uniden 6.0 answering mic plus the 2 hand sets 1 for the base and 1 for the ex phone what do I do because I had it on charge for 2 days now.i m disabled and need I phone to work thank you for any help u can give me or please send me 2 batterys 1 for each phone and I will send the 2 I just got with my new phone hope that works after I replace the batterys ty u can send to 1311 w rosewood ave sant cloud florida 34771 thank you

star - 30/11/17

It is very difficult to open the battery compartment.

Thomas Alessi - 25/08/18

Does it slide down or open out from where the finger groove is?

I can’t get it off.

K scott - 20/03/19

I had the same problem removing the back. I placed a knife in the center and was finally able to get it off. I think the red & black wire on the battery causes the problem.

Tanya Brown - 02/04/20

I tried knife, but I can't get battery cover off of one of the Uniden phones. I have new batteries but can't get the blasted cover off.

Carolyn B - 02/08/20

Schritt 2

Remove the white battery pack from the battery compartment.

Schritt 3

Remove the red-and-black-wired port from the plug directly under the battery compartment.

Schritt 4

Using a Phillips #1 screwdriver, remove the two .9 mm screws on the back of the device on each side of the battery pack.

Schritt 5

Using your fingers, gently lift and separate the front of the housing from the back housing.
Potential for device damage: While separating the back housing from the front, be sure to open from the sides as pictured.

Schritt 6

Gently remove the loose keyboard from the lined gel casing located under the front housing of the front of the phone.

Schritt 7

To better access the screen, remove the loose gel casing that sits under the keyboard.

Schritt 8

Lift out the attached motherboard piece and turn it sideways to access the side of the phone.
Potential for device damage: Use caution to avoid severing the wires that connect the motherboard to the phone.