VTech InnoTab 2 Back Panel Replacement

Geschrieben von: Roberto Valdes

Kommentare: 0

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

30 Minuten - 1 Stunde

Einleitung

A quick guide on how to remove stuck or clean buttons for your VTech InnoTab 2. If you are having trouble with the buttons on your InnoTab 2 feeling stuck or unresponsive follow these steps below.

Werkzeuge

Schritt 1

Apply slight pressure and slide the button above the battery cabinet to the right to open.
Remove battery cabinet cover by sliding away from the center of device.
This device requires 4AA batteries to function without the AC adaptor.

Schritt 2

Remove all nine plastic caps from the back of the device using the plastic opening tool.
These covers are made of hard plastic so they may be difficult to remove.

Schritt 3

Remove the hard rubber tab located by the cartridge slot using the plastic opening tool.
Be careful not to apply excessive force.
Once the rubber tab is removed unscrew the single 7 mm screw using a J0 screwdriver.

Schritt 4

Remove all ten 7mm screws from the back panel of the device using a JO bit screwdriver.
Do not use excessive force while removing the screws to prevent damaging the plastic case.

Schritt 5

Using the plastic opening tool, detach the back plate from the front piece.
Do not use excessive force. If the back plate does not gently come on double check that all screws were removed.
Once the back panel is removed, you will be able to see the motherboard and other components within the device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Roberto Valdes

Mitglied seit: 18/10/17

302 Reputation