Verizon Ellipsis 7 Charging Port Replacement

Geschrieben von: Anthony Arredondo
  • Kommentare: 4
Verizon Ellipsis 7 Charging Port Replacement

Schwierigkeitsgrad

Easy

Schritte

4

Zeitaufwand

10 Minuten

Einleitung

This guide will show you how to replace a charging port (Micro-USB) on a Verizon Ellipsis 7: invaluable to fixing a broken charging port and allowing continued use of the device. This process will need opening tools and tweezers, as well as a Phillips #00 screwdriver. Use caution, as performing the actions in this guide incorrectly could break your device.

  1. tFlGT4MUIv6jjfw1
    tFlGT4MUIv6jjfw1
    xLkdx5rjiVSfD3hM
    HVnZuE5EyMxWpZEe

    • Hold down the power button until the screen goes black to turn off the device.

    • Remove the SIM card from the device to prevent damage.

    • To remove the SIM card, open the SIM card cover on the side of the device.

    • Push SIM card in and pull it out after hearing a click.

  2. tAuw4OsdKdsZICES
    tAuw4OsdKdsZICES
    2yxLBYUbMyMpgXiS

    • Take off the back panel.

    • Pry open the back cover carefully with a plastic opening tool.

    • Use the opening tool to disconnect the cover completely. Do not attempt to pry the back cover off with your hands.

    • Be sure to pry open all sides of the device. Attempting to take off the back cover when part of it is attached may snap the cover.

  3. IgLdUZv3rwyyfYLI
    IgLdUZv3rwyyfYLI
    opRTejm2luLDJWW4
    bmelVH2CseCuGy6k

    • Remove the charging (micro-USB) port.

    • Unscrew the indicated screws using the Phillips #00 screwdriver.

    • The screws shown in the picture are the more common 4.76 mm.

    • Disconnect the ribbon cable connecting the charging port board to the motherboard using tweezers.

    • Use the tweezers to grab the sides of black, plastic connector. Do not grab from the wires or try to wedge it out from the bottom.

    • Be extremely careful when disconnecting the ribbon cable. It is very delicate.

  4. vEWYwMBhZC6aBBpO
    vEWYwMBhZC6aBBpO
    KUj6MFORS1HEH4gd

    • Remove the charging port board from the phone using tweezers.

    • Place the replacement charging port into the phone.

    • Be cautious when replacing the ribbon cable onto the new charging port board.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Anthony Arredondo

Mitglied seit: 10/10/16

412 Reputation

4 Kommentare

Guide was helpful in getting the back cover off.

I used a couple of guitar picks to pry the back cover off very carefully.

The Ellipsis 7 battery is glued into place.

I slid a credit card underneath the battery to break the glue adhesion from

the far end of the battery and worked my way towards the battery connector.

Just before removing the battery completely, I disconnected the battery connector

by prying it away from it's receptacle using the 2 guitar picks.

I positioned the credit card over the still sticky glue while positioning the battery.

Reattached the new battery connector, making sure no wires were caught under the new battery.

I then removed the credit card over the sticky glue and pressed the onto the metal battery mount plate.

Snapped the back cover on, starting at the end furthest away from the camera aperture, then snapped the back

cover up each side simultaneously up the sides. I tested all tablet functions immediately, as the battery came charged to 75%.

Works so far! Walt Taylor

Walter Taylor -

How do I get a Verizon Eclipse 7 charging port how can I order one how can I buy one please let me know

Jeffery -

How can the charging port if the part is not available?

Joe M

Joseph Malcor -

Perhaps if the author would provide the part number and/or compatible replacement parts it would be even more helpful!

Larry R -