Einleitung
This guide provides the instructions needed to remove the motherboard from the 781HD DVR camcorder.
Werkzeuge
-
-
Begin with the camcorder lens up on a clear working surface.
-
Remove the two 4mm Phillips #1 screws holding the switch plate in place. Rotate the device 180 degrees and repeat for the screws on the opposite side.
-
-
-
Slide the plastic opening tool into the seam between the front and back sections of the case and apply a small amount of force to pop the case open.
-
-
-
Move the plastic opening tool around the seam and apply force at each step to separate the front plate from the back plate and motherboard.
-
The battery is held to the front half of the case with double-sided tape. Peel it up with a finger, being careful not to damage the battery.
-
To reassemble your device, follow these instructions in reverse order.
3 Kommentare
It says no parts required, but it is instructions to replace the motherboard.
There is nothing about getting another motherboard, and how much.
How do you get a motherboard?
Where do we get one?