Einleitung

Prerequisite guide.

  1. yuLVV4mgqRlONuYT
    • Push the battery door

    • Open the compartment

    • Gently remove the batteries from their designated positions

    • Place them aside, away from the reach of children

  2. X23XQr6kIhhIkIhx
    X23XQr6kIhhIkIhx
    IQTWhZg4pEZNBvCO
    IgSgp26kIbx2XUgX
    • With caution, insert the plastic opening tools in between the disk and the glass face

    • It's a tight fit, so don't be afraid to apply a little bit of force

    • As soon as you hear a faint crackling sound, that means that the adhesive is budging out of place

    • Gently rotate the plastic spudger around the disk to get around the adhesive

    • Gently lift the metal disk

    • After the disk has been lifted, a wire and a small copper plate can be seen attached to the back of the disk

    • Carefully remove the wire and plate by peeling back the adhesive sticker that has been positioned around them

    The wire may be soldered to the metal plate and require desoldering/cutting to remove.

    Jason Kupka -

  3. JVF35j5r6RSDYrjG
    JVF35j5r6RSDYrjG
    LxH4TyWwswaZDkHc
    • After all the above steps have been completed, proceed by removing the glass face

    • Carefully insert a plasic spudger in the small gap that exist in between the glass face and the plastic back

    • Run the plastic spudger all around the scale to increase the gap size

    • Place a plastic spudger in every corner, since the feet of the scale are also attached to the glass face using adhesive

    • Carefully insert the metal spudger underneath the adhesive that is located underneath the feet of the scale, and gently keep pushing until the adhesive is out of place

    • Repeat the above steps four times

    • After all the adhesives has been removed, gently lift the glass face off

Abschluss

To reassemble your device, follow these instructions in reverse order.

omar shehadi

Mitglied seit: 23/03/17

204 Reputation

0 Kommentare