Xiaomi Air 12 Battery Replacement

Geschrieben von: Hannah Kwan
  • Kommentare: 7
Xiaomi Air 12 Battery Replacement

Schwierigkeitsgrad

Moderate

Schritte

11

Zeitaufwand

15 - 45 Minuten

Einleitung

Use this guide to replace the battery in your Xiaomi Air 12.

  1. i6Pov1VClnkVXAbB

    • Orient the computer so the Xiaomi logo is at the bottom of the device.

    Hello,

    I have a problem on my Mi air 12 , specifically with the lcd cable port on the mother board. I want to replace it but i can’t seem to find where to buy the parts.

    Pleas help me

    Kind regards

    L.

    lanusjeleus -

  2. mVYLPcyT3JTCsjsn
    mVYLPcyT3JTCsjsn
    dXEbVHMAUuLt16aZ
    HNNG5AxJksENWCAM

    • Insert the plastic opening tool underneath the top-middle rubber covering and lift upwards to reveal the hidden screw.

  3. WbYRWVkOADoaTEiJ
    WbYRWVkOADoaTEiJ
    bwuEyhmZ1YEFsyoQ

    • Remove the eight 3 mm screws using the Torx T5 driver by inserting the screwdriver into each screw and rotating counterclockwise.

  4. mNlUVPVVwAO3Cmof
    mNlUVPVVwAO3Cmof
    RwBNkoCCmgH6uAom
    XaddoYG45ovrPLFU

    • Insert the plastic opening tool into each side of the computer and push the tool downwards to pop open the back cover.

    • You will hear popping noises as you remove the cover.

  5. gbrgFwNuWUTkZM6s
    gbrgFwNuWUTkZM6s
    LnKHhIQgg1v5LYFZ

    • Remove the back of the laptop by gently lifting the casing upwards.

  6. YOK4lOqIGGA1HGAn
    YOK4lOqIGGA1HGAn
    14Uw6EcPEFNZnY1c

    • Detach the white and black speaker wires by pulling them from the small black tabs along the perimeter of the metal bracket.

    Would be nice if I found somewhere a replacement for the Mainboard….no luck so far and Xiaomi does not sell.

    Mk k -

  7. D5VxxRWZTFJOlE3r
    D5VxxRWZTFJOlE3r
    pBf6Qe5U1bxGHDXs

    • Remove the 1.5mm screw using the JIS #00 screwdriver.

  8. Z1GuyeV4QrcoqeFS
    Z1GuyeV4QrcoqeFS
    bdtkTuDyKxfctFfu

    • Lift the SSD up from the device and gently pull the SSD from the laptop.

  9. J3dDlfhCZdnV1d1F

    • Detach the red wire from the tabs on the perimeter of the metal bracket.

  10. w2LJlfOryvSonMSB
    w2LJlfOryvSonMSB
    IOTj1MtmS6HrDx45
    bTmy2kykPypcnNgc

    • Use a PH1 screwdriver to remove the five 2mm black screws.

    • Remove two silver 1mm JIS #00 screws.

    • There will be clear plastic spacers that come off with the silver screws.

  11. D4jcJkQOIu6dvDfF
    D4jcJkQOIu6dvDfF
    BTQi2F1YoJvdrOXX
    JbOOteLGpDbHMUfS

    • Lift the battery up and pull out from the device.

    • The metal bracket will come out with the battery.

    Dont forget to disconnect the battery wire!!

    Ben Egalo -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Hannah Kwan

Mitglied seit: 18/04/18

794 Reputation

4 Kommentare

I have a problem, the battery do not really charge, 100% is reach in few minutes, and it works less than 15 minutes on battery. Is anybody have a solution ? Bios update maybe ?

Migwell2 -

I got to pull out my bloated battery…. Though it could work with just the charger on stand by but it did not… Anyone knows where I can purchase new battery? Can't bring it to the shop because of quarantine but need to work from home.

Roma Monica Desunia -

I removed the bloated battery too. It can’t power on properly. The power light just just on and off around every 5 seconds. Is yours the same?

sdot -

after I change the battery it always says plugged in not charge, anyone has the same issue?

Anthony Jethro Lieander -