XtremeMac Luna Dock Circuit Board Replacement

Geschrieben von: Matt Ducasse
  • Kommentare: 0
XtremeMac Luna Dock Circuit Board Replacement

Schwierigkeitsgrad

Easy

Schritte

4

Zeitaufwand

1 - 2 Minuten

Einleitung

If your iPod won't connect to the Luna while docked, the dock may be faulty. Follow this guide to replace the dock circuit board.

  1. uNZsIUOQHPTal5Nj
    uNZsIUOQHPTal5Nj
    qVtqLqoYd5eYLm2u
    cUSriy6dhYHVQFO1

    • Flip the device over so that the batteries are closest to you.

    • Remove the battery lid by pressing the battery cover's tab and pulling it away from the device.

    • Push the battery against the spring and lift it out of the casing.

    • Repeat with the other battery.

  2. WuHRNRGHY21enmuZ

    • Unscrew all eight 12mm Phillips head screws with a Philips #1 screwdriver.

    • The iFixit 26 bit screwdriver kit will not reach the screws. Make sure to use a screwdriver that is thin enough to not get stuck in the screw holes.

  3. KiRFJZ6qs4PPAuoI
    KiRFJZ6qs4PPAuoI
    FeTiALQfLAHCEqqo

    • Flip the Luna back over so that the buttons are facing upward and the LCD screen is facing you.

    • Gently tilt the lid back 45 degrees so that the inside is exposed.

    • Be mindful of the wires inside of the Luna. It is easy to break a connection if a wire gets caught.

  4. CgYRKPQDGosK4BQC
    CgYRKPQDGosK4BQC
    iR4MQAK2HQUmhOyQ
    PGGgP12FNYSBZeDl

    • Unscrew the four black 7mm screws with the Phillips #1 screw driver that hold the middle circuit board to the top case.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Matt Ducasse

Mitglied seit: 18/04/13

12 Reputation

0 Kommentare