Yamaha YPG-225 Main Circuit Board Replacement

Geschrieben von: Lonnie Bissmeyer

Kommentare: 1

Yamaha YPG-225 Main Circuit Board Replacement

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

15 - 25 Minuten

Einleitung

Learn to remove and replace the main circuit board in your Yamaha YPG-225 keyboard with this guide. The process is moderately involved and requires the removal of many screws and light force for some parts.

Werkzeuge

Schritt 1

Turn the keyboard over so that the keys are facing the ground.

Schritt 2

Pop the tabs on the battery casing and remove it from the back plate.

Schritt 3

Locate the six batteries and remove them from the battery cavity.

what type of batteries? and how much ?

thanks godbless

colladonelson - 27/10/16

Schritt 4

Remove the six 10mm screws at the top of the backplate.

Schritt 5

Remove the seven 12mm screws in the middle of the back plate.

Schritt 6

Remove the eight 10mm screws from the side and the bottom of the back plate.

Schritt 7

As the face plate is no longer connected to the body of the keyboard, be careful to not drop the body when performing this step.
Flip over the keyboard.

Schritt 8

Lifting from the front and the back of the face plate equally, pull the face plate up and then back, away from the keyboard.
Be careful when removing the face plate. There are wires attached.

Schritt 9

Locate the main circuit board in the middle of the detached face plate.

Schritt 10

Use a plastic opening tool or spudger to carefully pry up the beige ribbon connectors and remove the wires from them.
Be sure to use a tool that is ESD safe!
Use a slightly upward force as parallel to the ground as possible.
Be sure to make a mental note or jot down the locations of the specific ribbon cables. Some are in close proximity to each other and it can be easy to forget which ribbon goes where.
Be sure to unplug the smaller ribbon that connects to a different circuit board.
Take care not to use too much force. The connectors are fragile, the ribbon wires are easily bent, and too much force may damage the circuit board if you happen to miss.

Schritt 11

Move the ribbons out of the way, and remove the eight 10mm screws in the middle that hold the circuit board down.
Remove the two 12mm screws in the corner of the circuit board.