Zenithink ZTPAD ZT280 C91 Motherboard Replacement

Geschrieben von: Keelie Beach
  • Kommentare: 0
Zenithink ZTPAD ZT280 C91 Motherboard Replacement

Schwierigkeitsgrad

Moderate

Schritte

9

Zeitaufwand

7 - 10 Minuten

Einleitung

In the process of disconnecting the motherboard you will begin with taking off 4 screws with a phillips screwdriver. Once that is done you should be careful with disconnecting all the cables connected to the board, making sure you don't tear any of the wires.

  1. RlFagdAehwjopZqk

    • Remove the two screws on the bottom using a Phillips #00 screwdriver.

    • For differentiation purposes, these screws are 4mm long.

  2. LCdXYb2rPWsRodtm
    LCdXYb2rPWsRodtm
    WfE5cobJL2yiLxdB
    DgswXUx2LnQvTKZA

    • Using a spudger, start prying the case apart by working around the edge slowly.

    • Be careful not to damage any of the latches that hold the back panel in place, especially if you are using a metal spudger.

    • While prying, be careful to not lose the power and volume buttons; the case is the only thing holding them in place so they will easily come out once the panel has been removed

    • Be careful to not damage the speaker cables, they will still be connecting both panels.

  3. 2Sa2MKTAtyUy2h61

    • Peel back the touch interface chip (which is on the top right of the motherboard, covered in yellow tape.)

  4. FgYjUpHBxGCxqn31

    • Flip up the small gate and unplug the ribbon cable shown.

  5. yVNyS2oHdiZEAjHX

    • Using a Phillips #00 screwdriver, remove the screws highlighted with the orange rings as shown in the picture.

    • For differentiation purposes, these screws are 3.5mm long.

  6. OjlswMTZDSRLKsKu

    • Slide back the plastic latch for the main display cable.

    • Carefully unplug the cable with tweezers.

  7. LyRAPnpPpxFaNsiT
    LyRAPnpPpxFaNsiT
    gyEteNdWXVLrvE5v

    • Slide back the plastic latch for the camera cable.

    • Carefully unplug the cable with tweezers.

  8. EvqmSsJOapbwMutw

    • Peel back the reflective tape.

  9. TrLNG3xGhMIZdxXS
    TrLNG3xGhMIZdxXS
    IPES4eBpDCAI6LD1

    • Lift up the motherboard assembly, starting by lifting up the top.

    • Be careful not to damage any of the ports on the underside of the tablet.

    • The camera cable will slide through a small notch and end up underneath the board.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Keelie Beach

Mitglied seit: 21/09/18

417 Reputation

0 Kommentare