iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement

Geschrieben von: Andrew Bookholt
  • Kommentare: 0
iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement

Schwierigkeitsgrad

Difficult

Schritte

8

Zeitaufwand

Keine Schätzung

Einleitung

Remove your rear display bezel to access your display's internals.

  1. twUoDXEVMw6TP6JK

    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  2. JbLkX3rgRZXxaRHj

    • Lift the battery out of the computer.

  3. jC32ZpNlmDsJq6Ul
    jC32ZpNlmDsJq6Ul
    x1UaUMfCNMSYNvG6

    • Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

    • If you don't have a 1.5mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

  4. OmiR2keh1rpWpIow
    OmiR2keh1rpWpIow
    WgsLwJlnASFSSIVW

    • Insert the flat end of a spudger perpendicular to the face of the display into the gap between the front and rear bezels near the upper left corner of the display.

    • Rotate the spudger away from the display to pry the rear bezel off the front bezel.

  5. cT5EBDL6NEDEcI2k

    • Run your spudger along the top edge of the front display bezel to evenly separate the two bezels.

  6. IQdoYy21oPc1PYmL
    IQdoYy21oPc1PYmL
    VgJwipRQUTHWLX1U

    • Working down from the upper left corner, use the flat end of a spudger to pry the rear bezel away from the left edge of the display.

  7. xpJHSJBjK1umUiFW

    • Use the flat end of a spudger to pry the rear bezel away from the right edge of the display.

    • If necessary, pry along the bottom edge of the rear bezel to separate it from the display assembly.

  8. AJhmFapJ3U6lku4B

    • Lift the rear bezel off the display assembly.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Andrew Bookholt

578335 Reputation

0 Kommentare