iBook G4 14" 1.42 GHz Keyboard Replacement

Geschrieben von: Walter Galan
  • Kommentare: 0
iBook G4 14" 1.42 GHz Keyboard Replacement

Schwierigkeitsgrad

Easy

Schritte

5

Zeitaufwand

5 - 10 Minuten

Einleitung

Replacing this keyboard is easy and takes only a few minutes.

  1. dyryFH1qMKJrDauv
    dyryFH1qMKJrDauv
    Q413YMZksVTfCyWf

    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

  2. FlTigsQtBKPUADVg

    • Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (shown in orange) 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

  3. 6NmHnFn6p6BOKBkL

    • Loosen the four silver Phillips screws that secure the RAM shield.

    • These screws will not come out all the way. The screws are held captive to the RAM shield to prevent them from getting lost.

  4. srTxFBXAiUSOt1Zu

    • Remove the RAM shield from the computer.

    • The four captive screws will come out with the RAM shield.

  5. Cqe3nEZaoAwZRvlP

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • When reassembling your iBook, make sure that you reconnect the keyboard cable before replacing the RAM shield.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Walter Galan

685540 Reputation

0 Kommentare