iBook G4 14" 1.42 GHz Rear Display Bezel Replacement

Geschrieben von: Andrew Bookholt
  • Kommentare: 0
iBook G4 14" 1.42 GHz Rear Display Bezel Replacement

Schwierigkeitsgrad

Moderate

Schritte

4

Zeitaufwand

Keine Schätzung

Einleitung

Internal Prerequisite.

  1. 6qYVuGhAAABauPOJ

    • Use a 1.5 mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

    • If you don't have a 1.5 mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

  2. HNyZEosXt6kdG2ar

    • Use your thumbs to slightly separate the rear bezel from the front bezel.

    • It is helpful to hold the opposing corner of the display stationary to aid in flexing the rear bezel away from the display.

  3. FDXLYOLfxJJdKmQS
    FDXLYOLfxJJdKmQS
    PIG2GNTRa6yJF4qS
    FtY5eZamVfGRod3I

    • Insert the flat end of a spudger into the gap between the front and rear bezels.

    • Rotate your spudger until it is parallel to the front face of the display.

    • Run the spudger around the perimeter of the display to separate the rear bezel from its retaining clips.

  4. diGXsCWPKxZJHNxr

    • Lift the rear bezel off the display.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Andrew Bookholt

578335 Reputation

0 Kommentare