iBook G4 14" 933 MHz-1.33 GHz RAM Replacement

Geschrieben von: iRobot
  • Kommentare: 0
iBook G4 14" 933 MHz-1.33 GHz RAM Replacement

Schwierigkeitsgrad

Easy

Schritte

11

Zeitaufwand

Keine Schätzung

Einleitung

One RAM slot will accept PC2100 or PC2700 chips up to 1 GB.

  1. JOMi1v5lvH4bM2Up

    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  2. sDUEOFFdDYPl4JYA

    • Lift the battery out of the computer.

  3. OShgOW4uVLDikm2d

    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again. The locking screw is in between the F5 and F6 keys and is a clear piece of plastic.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

  4. igRPdnpdBs2V5ial

    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

  5. kgFadqVQi6M1q1Ku

    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

  6. Mgl4dIiwGOQODFxD

    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

  7. QpKXiLu3r3HOrlDJ

    • Remove the four silver Phillips screws that secure the RAM shield.

  8. qBKRySlvStdsLSRx

    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

  9. E1OU2TEhhfVok3hE

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

  10. dTa2WqGSIwLq4vYn

    • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

  11. gdRSEGX4dQuTRNO3

    • Pull the chip directly out from its connectors.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

iRobot

Mitglied seit: 25/09/09

0 Reputation

0 Kommentare