Einleitung

Removing the rear display bezel does not require removal of the display assembly.

  1. JOMi1v5lvH4bM2Up
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  2. sDUEOFFdDYPl4JYA
    • Lift the battery out of the computer.

  3. IWIKoGTyT42RUN4X
    IWIKoGTyT42RUN4X
    LOWBZcdvfaAFeOtn
    • Use a 1.5 mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

    • If you don't have a 1.5 mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

  4. xSqrnPpT15lptQsv
    xSqrnPpT15lptQsv
    htdXBthtyHIBErbM
    • Insert the flat end of a spudger perpendicular to the face of the display into the gap between the front and rear bezels near the upper left corner of the display.

    • Rotate the spudger away from the display to pry the rear bezel off the front bezel.

  5. h1NiXRemDdW3moMs
    • Run your spudger along the top edge of the front display bezel to evenly separate the two bezels.

  6. AkvK1yPDQjHTaXMN
    AkvK1yPDQjHTaXMN
    ZMycdwPDKD34tQ6J
    • Working down from the upper left corner, use the flat end of a spudger to pry the rear bezel away from the left edge of the display.

  7. x6TaOFbQAwSGHHtV
    • Use the flat end of a spudger to pry the rear bezel away from the right edge of the display.

    • If necessary, pry along the bottom edge of the rear bezel to separate it from the display assembly.

  8. jSKP3H2bXoXic6Kf
    • Lift the rear bezel off the display assembly.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Andrew Bookholt

578335 Reputation

0 Kommentare