iPad 3 4G Front Panel Einheit ersetzen kurz

Geschrieben von: Brett Hartt
  • Kommentare: 4
iPad 3 4G Front Panel Einheit ersetzen kurz

Schwierigkeitsgrad

Mittel

Schritte

2

Zeitaufwand

Keine Schätzung

Einleitung

  1. fJxXaVwrD5fhPicg

    • Entferne die vier 2 mm Kreuzschlitzschrauben, mit denen das LCD am Aluminiumrahmen festgemacht ist.

    End of teardown. Start of disassembling.

    Dorothy Simler -

    The top left screw may be covered by black adhesive tape.

    Chat Pat -

    The ribbon cable on my unit was too short to lay it all the way down. I had to let it sit sideways.

    Petabyte Studios -

  2. bsb2BBUpsOYsIQAs
    bsb2BBUpsOYsIQAs
    jernUONBTLXtdMJB
    QXXfYvKLHQEn5gKL

    • Hebe die rechte Kante des LCDs mit einem Plastic Opening Tool oder einem Spudger aus dem iPad.

    • Klappe das LCD der linken Kante entlang um und lege es oben auf dem Front Panel ab.

    • Sei vorsichtig beim Bewegen des LCDs. Das Flachbandkabel ist empfindlich und kann reißen, wenn es zu sehr geknickt wird.

    I skipped everything beyond this point and proceeded with the detachment of the battery starting from the right side, one section at a time, with a credit card and a glue remover. I then removed the three screws around the battery connector (on both logic boards) and the one of the battery connector itself. I then lifted the boards up jointly just enough to free the battery connector from the screw hole cylinder that keeps it in place. I then cleaned up and removed all the adhesive from the base, inserted the new battery and glued it to the base. I then put the screws back, mounted the LCD, closed the glass with new adhesive, and powered on. The iPad booted normally and I proceeded with the calibration. I am aware that removing the boards is safer, but if you are careful you save a lot of time disconnecting and reconnecting fragile connectors from the boards.

    Ermanno Bellini -

Tinte & Feder

Brett Hartt

Mitglied seit: 13/04/10

125814 Reputation

0 Kommentare