iPad Mini 2 Wi-Fi Front Panel Austausch

Geschrieben von: Sam Goldheart
  • Kommentare: 6
iPad Mini 2 Wi-Fi Front Panel Austausch

Schwierigkeitsgrad

Schwierig

Schritte

3

Zeitaufwand

Keine Schätzung

Einleitung

nur Voraussetzung

  1. ZM1XLR2NqYLrDRpy
    ZM1XLR2NqYLrDRpy
    pbVCtfjcuerftHws

    • Hebe den Stecker des Digitizer-Kabels mit dem flachen Ende des Spudgers gerade aus seinem Anschluss heraus .

    • Sei beim Herausheben des Steckers aus dem Anschluss besonders vorsichtig - die Kontakte im Anschluss sind sehr empfindlich und gehen leicht kaputt!

    During reassembly at this point, be very careful to line up both sides of the connector. I came very close to destroying the digitizer cable connectors because I wasn't paying attention.

    Jeff G -

    I learned the hard way that we should be lifting from the short side of the connector, not the long side as shown here. The gold pins inside the FPC socket are very fragile and more likely to break when lifted as shown in this picture.

    Frank Buccella -

    Yes, I just learned that lesson as well. IMO a bit too ridiculously fragile.

    Daniel -

    Hi, i just broke this micro pins… it’s extremely fragile. Whats the name and were i can found a replacement to this connector? I ll try to find a friend that have a equipment for soldering this…

    Leonardo Marques de Souza -

  2. kJtwfkdC2Y4TsSJo
    kJtwfkdC2Y4TsSJo
    Zspsbvaon5NOH3oj
    6fapcJEUMHctNSKY

    • Schiebe den Spudger unter die Platine des Digitizers auf der Seite mit dem Akku und beginne sie vom Rückgehäuse abzulösen.

    • Hebe die Platine hoch, um sie vom restlichen Kleber zu trennen.

  3. NbbhjcXmlwfVe6gq

    • Hebe das Front Panel hoch und entferne es vom iPad.

Abschluss

Um dein Gerät wieder zusammenzusetzen, folge den Schritten in umgekehrter Reihenfolge.

Tinte & Feder

Sam Goldheart

Mitglied seit: 19/10/12

457712 Reputation

2 Kommentare

I'll give this quide a 3/5. The problem is the end where you just say reverse the steps. That is an easy out that too many people use. There are important things to do when re-assembling that are not pointed out that may come back to bite you just attempting to reverse the steps. I do like the stepped pictures showing before and after views. Overall the process is not that bad other than removing the broken glass which breaks a lot more as you go. A hair dryer on high worked fine for warming up the glue, you just need to be aware of cleaning the area of glass bits before turning it on. Glad I didn't pay somebody big bucks to do this job.

italternatives -

Due reassebling its really important to bend the digitizer cable with a spudger inside the case. If you just press the Front down the cable will be between adhensive and case. So near the home button, it won't fit very well!!

itf7o -