iPhone 4S Lautsprechergehäuse ersetzen lang

Schritt 1

Entferne die folgenden Schrauben, mit denen das Dockanschlusskabel am Logic Board festgemacht ist:
Eine 1,5 mm Kreuzschlitzschraube
Eine 1,2 mm Kreuzschlitzschraube
Entferne die metallene Abdeckung des Dockanschlusskabels.

the ifixit #000 screwdriver is too big for the 1.5 mm Phillips screw &

1.2 mm Phillips screw!!!!!!

mothusi motswasele - 02/02/16

Schritt 2

Heble das Dockkabel mit einem Plastic Opening Tool von seinem Sockel auf dem Logic Board hoch.

Schritt 3

Löse das Dockanschlusskabel von dem Kleber, mit dem es am Logic Board und der Seitenwand des Lautsprechergehäuses festgemacht ist.

When reassembling, peel adhesive strips off dock connector cable, but do not stick them down. First plug the cable into it's socket, then stick down the cable. It will make locating the plug in the socket easier.

rob -

The metal piece with white and black areas stuck to the adhesive and pulled off the board for me. There are some chips under it. It popped back on the board and didn't seem to be a problem.

DMcG -

Schritt 4

Heble das Antennenkabel mit einem Plastic Opening Tool vorsichtig von seinem Sockel auf dem Logic Board hoch.
Hole das Antennenkabel unter den Metallfingern am Logic Board hervor.

Note, the pictures do not show the routing of the cable under the metal finger next to where the battery was. Make sure the cable is replaced under the finger when reassembling.

rob -

The trickiest part for me was reconnecting the antenna cable to the socket. Do it carefully!

A tip is to mold the cable and connector so that it stays correctly aligned with the socket, and all you have to worry about is pressing the connector against the socket.

Felipe Pozzer -

Bump on the comment re: no picture here shows the proper cable route. The text mentions being careful to route it under the metal finger, but no way to know where that it is from these pictures. The re-route is: around the left side of the screw socket and then the right side of the silver thing (finger) which is to the right of the battery connector.

gregsrow -

In this picture (actually in all of them) the cellular antenna cable is not routed properly (red line). Be sure when reassembling your iPhone 4s to route the cable around the metal finger (yellow line).

drlewis506 -

Schritt 5

Entferne die zwei 2,4 mm Kreuzschlitzschrauben, mit denen das Lautsprechergehäuse am Außengehäuse festgemacht ist.

Schritt 6

Entferne den kleine schwarzen Abstandhalter, der sich unter der Kreuzschlitzschraube nahe dem Vibrationsmodul befindet.

Schritt 7

Hebe die Lautsprechergehäuseinheit mit einem Plastic Opening Tool aus dem Gehäuse heraus und achte dabei darauf, die EMI Finger an der angebrachten WiFi-Antenne nicht zu beschädigen.
Entferne die Lautsprechergehäuse einheit.
Bevor du die Schrauben der Lautsprechergehäuseeinheit wieder eindrehst, stelle sicher, dass der WiFi Federkranz unter dem Rand des metallenen Gehäuses angebracht ist (wie im dritten Bild zu sehen ist).
Vor dem Wiederzusammenbau, reinige alle Metall-zu-Metall Kontakte zwischen den Federkränzen der WiFi Antenne und dem Gehäuse des iPhones mit einem Entfetter oder Isopropylalkohol. Die Öle an deinen Finger können Störungen bei der Funkübertragung verursachen.

The spring contacts on the speaker bottom make re-installing a bit tricky, since they make the speaker pop up until the screws are back in. If this happens, one or more of the fingers that are supposed to be under the case will pop out. What I found worked was to put the speaker in, getting the metal fingers under the case as directed, and then hold the speaker down with while putting the two screws in, along with that triangle piece.

gregsrow -

I was holding the plastic triangle spacer in a pair of tweezers, and it shot out like a watermelon seed ya squeeze between your fingers!

It shot (I think) into a high-clutter area of the room and I can't find it. I made a replacement spacer out of plastic and I'll hope it works. Where am I going to buy a stupid little replacement spacer? I think I'm outta luck..

Mike McIntosh - 13/01/17

Im reassembling the phone and as I was going to place the speaker back on, two rubber pieces popped out. Based on the images here I cant seem to determine where they go. Please help.

Isabella - 04/09/17

iPhone 4S Lautsprechergehäuse ersetzen lang

Einleitung

Werkzeuge