Einleitung
If the iRobot Looj 120 has stopped working and all the motors are okay and the battery is charged, then there may be a problem with the circuit board within the handle. This guide will show you how to replace the circuitry in the remote handle.
Werkzeuge
-
-
Remove the four exterior screws located under controller and on the handle.
-
Remove the five screws shown, and then carefully remove top plate. Electrical components are attached to top plate.
-
Abschluss
To reassemble your device, follow these instructions in reverse order.
Ein Kommentar
Where can you get the replacement circuit board for the remote control?