Einleitung

To gain access to any replaceable part, at least some of the disassembly outlined in this guide is required.

  1. XySUJOBLWLPZEZrB
    XySUJOBLWLPZEZrB
    CCZqoCZLTGGev2m5
    5OjAnkTqxGslZ4hp
    • Place the phone on a flat surface with the front facing down and the antenna fully extended.

    • Use a spudger to remove the circular rubber cover from the base of the antenna.

    • Remove the 3.2 mm Torx T5 screw located under the rubber cover.

  2. GBrqFkWjC2ZQEAuT
    GBrqFkWjC2ZQEAuT
    JnuQ1FT2Y5GiZeM6
    yPQ6yDs1XkxZ2aQy
    • Remove the antenna by grasping from the white plastic piece just below the antenna and pulling away from the phone.

    • Do not grasp the black antenna piece to pull it out. Doing so may damage it.

  3. QfMrSaqWZyu2iBrT
    QfMrSaqWZyu2iBrT
    VsTq4AZAmFxfqOeC
    cHDOdGhluP3MeVyZ
    • Place the phone on a flat surface with the front facing down.

    • Insert your finger under the gray plastic cover at the bottom end of the phone.

    • Lift the cover off the phone.

  4. 5XEqZJIj6On6AtOD
    5XEqZJIj6On6AtOD
    ZeCKmvCmQGCTVvVN
    rFtFejQWxCj2dYlv
    • Place your thumb in the notch in the lower left corner of the battery compartment.

    • Lift the battery up and away from the phone.

    • Remove the battery.

  5. SpAt2TvmMsnGKD2I
    SpAt2TvmMsnGKD2I
    XDPbpBFZ2QwKXvFP
    • Locate the metal slider that holds the SIM card in place.

    • Push the slider away from the metal flap which contains the SIM card. The flap will pop up.

  6. WgBX5tZUlQjhttRU
    WgBX5tZUlQjhttRU
    FiXrUNXXAXhwfyjr
    iMqPaZuBoRiFL3gu
    • Lift the metal flap to gain access to the bottom of the SIM card.

    • Remove the SIM card by sliding it out parallel to the bottom of the flap.

  7. sAecVplwKIGpxyer
    • Extend the antenna.

  8. Y2pWJpL4qHTOdevL
    • Remove the four 4.8 mm Torx T6 screws from the corners of the back of the phone.

    • If the antenna is not fully extended, the top left screw will not be accessible.

  9. 4jRIiuN6QRO1PNZB
    4jRIiuN6QRO1PNZB
    f4JnyFPjpqEVrPag
    XFPpvI3CBNMhOkLZ
    • Gently lift off the back half of the phone and set to the side.

    • Permanent circuit connections prevent the cover from completely separating from the phone. Do not attempt to disconnect these circuits.

  10. WECm1QOONBqX41Kw
    WECm1QOONBqX41Kw
    YCWpmpB62QLQyJGB
    MYckeMTfOsBnIsaZ
    • Gently lift the end of the circuit board farthest from the phone hinge.

    • The circuit board is permanently connected to the phone casing at the end nearest to the hinge.

    • Grasp the keypad at the bottom of the phone, raise it, and pull it away.

  11. r5hKuNZXAXUBnUTm
    • Exploded view of all phone components.

Nathan Heavner

Mitglied seit: 22/10/12

3 Reputation

0 Kommentare