Samsung Galaxy S10e Mittelrahmen tauschen

Geschrieben von: Adam O'Camb

Kommentare: 9

Schwierigkeitsgrad

Mittel

Schritte

Zeitaufwand

5 - 20 Minuten

Einleitung

Grundständige Anleitung zum Entfernen des Mittelrahmens in einem Samsung Galaxy S10e. Der Mittelrahmen beinhaltet die kabellose Ladespule sowie die NFC-Spule.

Werkzeuge

Schritt 1

Entferne die acht 3,9 mm Kreuzschlitzschrauben, mit denen der obere Mittelrahmen am Smartphone befestigt ist.

Again, criminal lies! These screws have different length! Take notes which are where! There are at least 4 versions of antenna/coil modules, so each time it may be a little different.

Someone fromjapan - 23/08/23

Interesting observation! I did not see this comment until after I reassembled the midframe and closed everything, so I can not confirm. If true, I either got lucky or it didn't matter.

WL1 -

I'll note this and see about maintaining the same order for reinstallation -

Gee Foe -

Mine appeared to be all identical, so it was easy

Gee Foe -

The screws on my SM-G970F/DS were all identical.

James Beegle -

The screws in my phone were also identical. I think the "criminal lies" commenter above was confused and was using these instructions to repair a different phone. Too many of his or her comments are just not relevant to this job.

MikeT-NYC -

Schritt 2

Schiebe ein Plektrum unter die untere rechte Ecke des oberen Mittelrahmens, um den Kleber zu durchtrennen, mit dem er am unteren Mittelrahmen befestigt ist.

I also had to use a little bit of heat here from the iOpener.

MikeT-NYC -

Schritt 3

Setze die Spitze eines Spudgers in den kleinen Ausschnitt auf der rechten Kante des Bereichs aus Plastik des oberen Mittelrahmens bei der Bixby-Taste ein.
Heble den Mittelrahmen mithilfe der Spudgerspitze vom Rahmen des Smartphones ab.

Criminals! These instructions are given for breaking your phone! Never use the puncher-picker! The antenna module, after gently unglued in the single spot, is pulled down! Not up! DOWN, I said! And it comes off without any force. Minimal force will be required to push it back (after putting it flat on place).

Someone fromjapan - 23/08/23

Schritt 4

Hebe den Mittelrahmen an dem Bereich aus Plastik an und entferne ihn aus dem Smartphone.
Setze beim Wiedereinbau zunächst die Oberkante der Baugruppe in den Rahmen des Smartphones und drücke dann vorsichtig den Rest der Baugruppe nach unten, damit sie einrastet.

In my phone there was a lot of residual adhesive on the top section, so I initially just flapped it over like a hinge while I finished the other steps. For me, I found, and it should be emphasized, for the reinstall, the top edge needs to be placed flat and snapped UP into the chassis for it to fit.

WL1 -