Dell XPS 15 9520 Battery Disconnect

Geschrieben von: Clay Eickemeyer
  • Kommentare: 1
Dell XPS 15 9520 Battery Disconnect

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

No estimate

Einleitung

This is a prerequisite guide! This guide is part of another procedure and isn't meant to be used alone.

  1. ISvdFZQIAMFXTwOW
    ISvdFZQIAMFXTwOW
    AMMa6PdHTnd46OxV

    • For your safety, discharge the battery below 25% and power down your device before disassembly.

    • Use a Torx T5 screwdriver to remove the eight 3.3 mm-long screws securing the back cover.

  2. CUDAEEIcYHlWpo1R
    CUDAEEIcYHlWpo1R
    mrHZhsWKWg2yjrAi

    • Insert an opening pick between the bottom-left corner of the aluminum back cover and the chassis.

    • Leave the pick inserted before continuing to the next step.

  3. VBsF61aIcWpYEo4y
    VBsF61aIcWpYEo4y
    efxqpGT6HHiQ6jA3

    • Insert the flat end of the spudger into the gap you just created.

    • Pry up to release the corner clips.

    • Repeat this process for the opposite corner of the back cover.

  4. rBY4eBo6PKMHb2jI
    rBY4eBo6PKMHb2jI
    gURGNbU3akbPbtGx
    IGwdpDcSn6fGljfu

    • Reinsert your opening pick under the aluminum cover at the front edge of the laptop.

    • Pry to loosen the cover.

    • Pry at multiple locations along the front edge to release all of the retaining clips.

    • Do not use a sliding motion along the front edge. This may damage cables near the trackpad.

  5. CXSn5yWMDCrIIww3
    CXSn5yWMDCrIIww3
    QEBIcLtZfVMZOXjq
    ZHxQNkBmMoAomeM5

    • The edges of the back cover are very sharp. Use caution when handling it.

    • Lift the back cover off the chassis and remove it.

    • If the back cover feels stuck to the chassis, use an opening pick to release any remaining clips around the back cover's perimeter.

    WHEN THEY SAY THEYRE VERY SHARP THEYRE VERRRY SHARP I CUT ALL MY 4 fingers opening it Stay safe yall

    Yassin Eisa -

  6. GfxBuCOQDfUre11j
    GfxBuCOQDfUre11j
    KpRmnD2rcu5qOweh
    PGyhxYvGTrt1feyW

    • Use the flat end of a spudger to push the battery connector's square tab away from the socket and disconnect it.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Clay Eickemeyer

Mitglied seit: 19/09/22

100126 Reputation

0 Kommentare