Microsoft Surface Pro 4 Antennenhalterung tauschen

Geschrieben von: Sam Omiotek
  • Kommentare: 10
Microsoft Surface Pro 4 Antennenhalterung tauschen

Schwierigkeitsgrad

Schwierig

Schritte

2

Zeitaufwand

Keine Schätzung

Einleitung

Grundständige Anleitung, nicht zum eigenständigen Gebrauch gedacht.

Diese Anleitung zeigt, wie die Antennenhalterung im Microsoft Surface Pro 4 ausgetauscht werden kann.

  1. 54uLjQBUqFZc1EFA

    • Entferne die vier 4,5 mm Torx T5 Schrauben, mit denen die Antennenhalterung befestigt ist.

    This screw bit was not included in the battery replacement kit. Only Philips and Flathead were included.

    ComputerRepairAcct -

    This Torx bit was not included in the battery replacement kit. Only a Philips and Flathead bit

    ComputerRepairAcct -

    this screw bit was not included, lucky I did not get the battery from you guys and that battery had this kind of screw driver included.

    Stars V -

    used phillips bit and stripped screws

    Too old to change -

    Do the copper "teeth" need to be hanging freely like on the picture (when re-closing the tablet) or is it necessary to plug them in the plastic below the antennas?

    Diyoyo -

    Dude ;) the torx bits are in the plastic bag where the gloves and the tishues are. I missed them too an used my own one and found them while reasembling :)

    Dude -

  2. QCwNOfsMSfRRyodx
    QCwNOfsMSfRRyodx
    uJnAjGV22JRVxFDT
    d6qTZaQ52TbuaKpk

    • Entferne vorsichtig die Antennenhalterung.

    • Achte darauf, dass sich keine Kabel verfangen. Hole die Halterung nicht mit Gewalt heraus, wenn sie festhängt.

    I had ripped through 2 of the 3 antennas when cutting through the top adhesive. Not sure how anyone removes this display without ruining at least one of them.

    I saw on Reddit this post: https://www.reddit.com/r/techsupportmacg...

    It works perfectly! My wifi was one that was cut. It’s now made of aluminum foil and is pulling down 147Mbps and pushing 80.88Mbps up.

    Joshua Snavely -

    A ce stade il semble important de faire attention au micro. Pour ma part, il avait un résidu de colle entre celui-ci et le support à retirer.

    Jean-Claude Guinel -

    On my device the mic is glued to the antenna board. I'd recommend to detach it's ribbon cable from the motherboard before removing the antenna board

    WapitiSumpf -

    what is this clear round plastic piece that came off with the display glue? cant add picture

    Too old to change -

Abschluss

Um dein Gerät wieder zusammenzusetzen, folge den Schritten in umgekehrter Reihenfolge.

Tinte & Feder

Sam Omiotek

Mitglied seit: 25/02/19

96268 Reputation

0 Kommentare