Samsung UBD-K8500 Circuit Board Replacement

Geschrieben von: Syeda Zainab
  • Kommentare: 2
Samsung UBD-K8500 Circuit Board Replacement

Schwierigkeitsgrad

Very easy

Schritte

6

Zeitaufwand

10 - 20 minutes

Einleitung

This guide will help you replace the circuit board for the Samsung UBD-K8500. If your circuit board becomes faulty after exposure to heat, an impact, power surges or overloads, access this guide to replace the defective circuit board. A fragmented connection from the motherboard to the daughter board may cause glitches and errors in reading discs.

  1. Z51FWrA6FHNKHlVU
    Z51FWrA6FHNKHlVU
    nxLgpk4DFxYjoUdd

    • Remove the six 10 mm screws from the back of the unit using a Phillips #0 screwdriver.

  2. M1N4CXO1K246QLFf
    M1N4CXO1K246QLFf
    Wf1eLJ1drhOgfktx

    • Carefully lift up the top panel.

    • There is a cables that must be disconnected before completely removing the panel.

    • Detach the cable connecting the top panel to the motherboard.

    • Take the top off and set it to the side.

  3. ePgSrReMRWdyYZQU

    • Using your fingers, carefully pinch the clipping part of the four connectors and gently pull them out of their sockets.

  4. BVugOLJghGjQESVt
    BVugOLJghGjQESVt
    kBy3GxGNNT2ZHefN

    • Gently pull out the two blue tabs of the ribbon connectors.

  5. PivRS6QTtoMtIsZn
    PivRS6QTtoMtIsZn
    NVjqRqGvWrSNsqoH

    • Remove the three 7 mm screws from the circuit board using a Phillips #0 screwdriver.

  6. SqsTXWBRbFuJurUq
    SqsTXWBRbFuJurUq
    XAX6jJG4ioiUAWwZ

    • Gently pull out the circuit board.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Syeda Zainab

Mitglied seit: 12/09/23

273 Reputation

2 Kommentare

is it possible to swith or remove the wlan(card) or is it fixed on the board?
thanks

richrd -

¡Buenas!, ¡yo tengo un samsung UBD-K8500, pero me está dando problemas con el mando y el sensor, que no me reconoce el mando, aunque el mando emite señal, pero el DVD no reacciona, lo abrí para ver dónde estaba el IR, pero no lo encuentro!, ¿y necesito saber, qué puede estar pasando y cómo solucionarlo, ya que sin el mando, es inútil usar el DVD, sólo con CDs de audio?, ¿y dónde se encuentra el IR específicamente?, ¡gracias!...

alex hernandez -