Einleitung
-
-
Use a tri-point Y000 screwdriver to remove the 1.0 mm‑long screw securing the rear camera connector cover.
-
-
-
Use tweezers to unlatch the rear camera connector cover from the logic board and remove it.
-
-
-
Use the point of a spudger to pry up and disconnect the three rear camera press connectors.
-
-
-
Use a Torx Plus 4IP screwdriver to remove the three screws securing the rear camera assembly:
-
Two 4.0 mm‑long screws
-
One 4.4 mm‑long screw
-
-
-
Use the point of a spudger to pry up the top edge of the rear camera assembly.
-
Grab the assembly with your fingers and remove it.
-
Abschluss
To reassemble your device, follow these instructions in reverse order.
