Altec Lansing BoomJacket Speaker Replacement

Written By: Ryan Byrnes
  • Comments: 2
Altec Lansing BoomJacket Speaker Replacement

Difficulty

Moderate

Steps

8

Time Required

10 - 20 minutes

Introduction

Are your speakers not producing the same amount of BOOM that they used to? Perhaps repairing your speakers is the way to go.

  1. Dww1lNNcSnKEfaOA

    • Using your hands, remove the pegs (4+4) from the front and back of the speaker.

  2. EZcPhuWsTvSIukDF

    • Remove the outer black rubber housing of the speaker.

  3. BCe2JsHYDSeAVofm

    • Remove the inner blue rubber housing from the speaker.

  4. TaMsC2UOaok51QSD

    • Pull out the two black wire meshes using a metal spudger.

    • Be careful not to damage the metal casing.

  5. RFexdyWNTAlBNH2Z
    RFexdyWNTAlBNH2Z
    mGMNuJAc5kH1dDAI

    • Using tweezers remove the rubber stoppers (4 at the back + 2 at the front).

  6. SSqXdmE4QXZNPN2C

    • Using the size PH1 screwdriver remove the screws (4 around each speaker).

  7. Zr1WZWFvIZTxpSGG

    • Pull the case apart and you will be able to see all the components inside the speaker.

  8. QxXmuUkDnmRtftDw

    • Remove the speakers (not entirely because of the wiring) by gently pulling each speaker up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ryan Byrnes

Member since: 12/04/17

848 Reputation

2 comments

Where do I find the correct part to replace the charging port on my boom jacket?

Rockstar -

1.1" External Magnetic Type Round Slim Plastic Shell Speaker 8 Ohm 0.25W 2 Pcs

Eeshton -