Canon PowerShot SD1300 IS Shutter Button Replacement

Written By: Clayton
  • Comments: 0
Canon PowerShot SD1300 IS Shutter Button Replacement

Difficulty

Moderate

Steps

4

Time Required

5 - 20 minutes

Introduction

This guide will show you how to properly replace a faulty shutter button.

  1. jcI64ey6fy5lcxg1
    jcI64ey6fy5lcxg1
    SUQeTbeARJ5fxRVD
    pQopMJUoqABPUWjU

    • Remove the two 2mm J00 screws on the right exterior.

    • Remove a single 4 mm J00 on the bottom exterior.

    • Remove a single 3mm J00 on the left exterior.

  2. bErnSQnTKxWyhhjA

    • Once the front shell of the camera is removed the back shell should slide off just the same.

  3. HuRuVANJk5BrXURR

    • Use your Heavy-Duty Spudger to remove your faulty shutter piece.

  4. 2vQn3BxJAbV4sQja

    • Insert Heavy-Duty Spudger under shutter button to release shutter button.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Clayton

Member since: 20/03/17

560 Reputation

0 comments