DCC-3200 Faulty Power Cord Replacement

Written By: Hamad Khan
  • Comments: 0
DCC-3200 Faulty Power Cord Replacement

Difficulty

Moderate

Steps

7

Time Required

No estimate

Introduction

This guide will go over the step by step replacement process of a faulty power cord on a Cuisinart DCC-3200 coffee maker. All recommended tools for this repair are listed at the beginning of this guide.

  1. SmigZ1IK1s512t6C

    • First, please be sure that the device is unplugged and that there is no water in the reservoir.

    • Check the power cord for frays or cracks.

  2. UnqSR6nV54YOKuFi

    • If the cord appears fine, please flip the device upside-down and unscrew the 4 screws on the bottom.

  3. 4CFGCEQpCt62xCuA

    • Remove the bottom panel and unclip the power cord from the panel.

  4. 23IUCPZ35A4IA2Gf

    • With the front facing towards you upside down, to the top left of the circular hotplate is a beige circuit board with two screws on either side holding it in. Please unscrew them.

  5. kVcONGZAWDOiVBpa

    • Carefully remove the circuit board and unplug the gray ribbon wire that is plugged into it.

  6. ZSq6RXVuuk6PnXDq

    • Check to see if the power cord is connected properly to the circuit board.

  7. MIXaqGk4aDuxcuNO

    • Strip the wire and twist with the other or solder it back on.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Hamad Khan

Member since: 04/03/16

379 Reputation

0 comments