DeLonghi ECAM Series power board replacement

Written By: VauWeh

Comments: 1

DeLonghi ECAM Series power board replacement

Difficulty

Moderate

Steps

Time Required

No estimate

Introduction

If the device cannot be switched on at all, the power board is probably defective. Here we show how it can be replaced. When buying spare parts, look for the appropriate code from DeLonghi: Cod.DeLonghi 52.......... It can be found on a sticker on the circuit board.

Tools

Step 1

Unplug the power cord!
Remove all attachments such as water tank, pulp drawer, brew group.
Turn the machine with the back facing you.
Remove five Torx T20 security screws.
A small hurdle: These screws have a pin in the middle, so the screwdriver must have a hole.

Step 2

Lift out the back.
The following components are immediately visible:
grinder
pump
flowmeter

Sehr gute Anleitung. Die Security Schrauben der Rückwand können auch durch normale Kreuzschlitzschrauben ersetzt werden. Natürlich mit gleichen Abmessungen. Es erleichtert bei späteren Reparatur Arbeiten die Werkzeuge Auswahl , da überall Kreuzschlitzschrauben verbaut sind.

Willi Greubel - 25/05/21

Step 3

Also slide the cover - if not already done - on the water tank side backwards and remove it.

Step 4

The power board is located under the cover. It is fixed with four screws in the corners and connected with a lot of cables.
Move the cables a bit to the side and unscrew the four Phillips screws in the corners.

Step 5

The cables have many different connectors and can almost not be confused. Make a special note of where the flat connectors are connected.
The flat connectors can be disconnected more easily if you lift the cover in the corner of the device to the side.
Lift the board out a few centimeters.
Carefully loosen all connections. Some are secured with latches that you have to push away first.

Conclusion

Work through the steps in reverse order to reassemble your device.

Author

VauWeh

Member since: 19/10/15

167120 Reputation