Dell XPS 13 Back Cover Replacement

Written By: Ella Herrmann

Comments: 12

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

This guide will explain how to replace the back cover of the Dell XPS 13.

Tools

Parts

Step 1

Remove the eight 4 mm T5 Torx screws from the bottom cover.

Missing a step about removing the tiny Phillips head screw under the XPS flip up cover in the middle. Also, there are hooks all the way around the cover so it doesn’t simply lift off.

curtis_p_brown - 04/11/17

What about step 3???

Peter Hecht - 03/09/20

Please dont hurry , take your Time to follow this procedure. It takes 20 min (not 5) and step 4 requires half of this Time. Good luck.

Peter Hecht - 03/09/20

+1 Peter Hecht is right - getting the little clips the back is snapped on with is time consuming and a bit fiddly for people not used to “spudging” off covers. Starting from the back is the key those come loose much easier and help with the rest

Doug Steinschneider - 15/10/20

Step 2

Use a plastic opening tool to pry open the 'XPS' flap in the middle.

No flap or screw on the XPS 9370, just a press-fit latch at the centre of the cover. This can be gently prised off.

Alan Thomas - 03/02/21

Step 3

Remove the single Phillips screw hidden beneath the flap.

Step 4

Use opening picks or a plastic pry tool to pry open the case clips, beginning from the back edge.

It’s not that easy to lift actually, cause there are latches. Had t release them gently all around beforehand.

Davit Barbakadze - 21/09/17

Also there’s one additional screw under that plate on the bottom!

Davit Barbakadze - 21/09/17

Maybe the later models are different, since it should be from the front: https://www.youtube.com/watch?v=xFIE2SKs...

shigmas - 11/05/20

Very difficult step, Proceed very carefull

Peter Hecht - 03/09/20

If you are replacing the battery of a 9360 or latter (2016 onward) make sure to do the FRONT first. There are latches on the back that you may break if you try to force it open that way. After prying up the front and the sides, just lift up the front like you would open a hinged box. You shouldn’t feel that much resistance as the back hinges off towards you after you’ve lifted it around 30-40 degrees.

Giacomo P - 12/12/20