Fujitsu Lifebook Stylistic Q584 Motherboard Replacement

Written By: Casey
  • Comments: 1
Fujitsu Lifebook Stylistic Q584 Motherboard Replacement

Difficulty

Moderate

Steps

17

Time Required

15 minutes

Introduction

This guide will allow you to replace the motherboard if it is burnt up or to upgrade.

  1. 2gN3ZT1LcTcDtYKb

    • Remove the white sticker covering the screws (if applicable).

    • Use the PH1 screwdriver to remove the four 2 mm screws from the the backside of the device.

  2. XqGwyZCPSvPIuTdS

    • Insert the plastic opening tool along the seam of the back case.

    • Gently slide the plastic opening tool along the entire seam popping the clips free.

  3. qfg4IOgJlri6pRnq

    • Carefully lift the back case and remove the smartcard ribbon from the motherboard.

  4. YbmKFvFqTfCMniNw

    • Remove the ten 3mm screws with a PH00 screwdriver from the shield.

  5. 1qTxHcIZc5FZ5gRh

    • Remove the grey docking station port cover.

  6. FsCMAvueYsT1yIPB

    • Gently slide the plastic opening tool along the entire seam popping the clips free.

  7. VakGTMiHnkGUFgXF

    • Lift the shield away from the device and remove the fingerprint scanner's ribbon from the motherboard.

  8. QwDEjM225WJNuIMc

    • Pull up the cord that connects the battery to the motherboard

  9. 6ZmmEIHPJkXsYQJc

    • Remove seven 1mm screws using a PH00 screwdriver.

  10. s1kkvuViCVv3HFsH

    • Disconnect upper peripheral ribbons from motherboard.

    • Disconnect left peripheral ribbon from motherboard.

  11. LDiYX1HN1eDmUMHH

    • Gently lift the battery from the casing.

  12. sFlTIr2uWeHyyL6U

    • Remove three 3mm screws using a PH00 screwdriver.

  13. h5aVMGgsPfLba1Er

    • Remove all of the ribbon connector cables from the motherboard using an ESD-safe spudger.

  14. HMdqiAes36J4OyUa

    • Gently pry up the motherboard.

  15. eGs2wJ5pUbxkanks

    • Gently lift the foil tape under the motherboard to reveal the connector.

  16. tPGjSKSZHA5AGokF
    tPGjSKSZHA5AGokF
    TBVJ15Kfp2oBdIMU
    X5xcQpkG6dQfXR3c

    • Remove the clip holding in the connector with an ESD-safe spudger.

  17. BPdUIYQa24B1ZwsU

    • Remove the connector with an ESD-safe spudger.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Casey

Member since: 25/03/19

256 Reputation

One comment

step16, that metal clip is supposed to be lifted up, not departed away

net ho -