GoPro HD Hero2 Rear Case Replacement

Written By: David Hodson
  • Comments: 4
GoPro HD Hero2 Rear Case Replacement

Difficulty

Moderate

Steps

5

Time Required

No estimate

Introduction

This guide is a prerequisite for removing the mini HDMI port or replacing the rear case.

  1. oiHOhCRG4lGHsAPn

    • Remove the four Phillips #00 screws securing the rear case to the rest of the device:

    • Two 5.5 mm coarse thread screws.

    • Two 4.4 mm fine thread screws.

  2. tPP1nfpn1jj4oQAI
    tPP1nfpn1jj4oQAI
    1h6JfYeStXKAjwQX

    • Slide the edge of a plastic opening tool underneath the sticker on the rear cover and gently peel the sticker up.

    • Once you have enough of the sticker peeled up with the plastic opening tool, grab an edge of it with your fingers and pull it off completely.

  3. JErOqXehntpUMd1f
    JErOqXehntpUMd1f
    N46CPHQKWe53moYG

    • Grasp the rear case and lift it off of the front case.

    • Do not try to completely remove the rear case yet, as it is still attached by the display port ribbon cable.

  4. rWvUkWUIoudMxWUk
    rWvUkWUIoudMxWUk
    IOr6QoLmL622oPht

    • Using a plastic opening tool or your fingernail, flip up the locking tab on the SD board ribbon cable ZIF connector on the motherboard assembly.

    • Be careful that you are prying on the locking tab, and not the connector itself.

    • Use a pair of tweezers to remove the SD board ribbon cable from its connector on the motherboard.

    Hallo, ich fürchte bei mir ist das obere Flexkabel defekt.(oben mittig, welches nach hinten weg geht) Gibt es da ersatz oder reperaturen?

    moejoe DO -

  5. kteHI4YtZQjLSecH
    kteHI4YtZQjLSecH
    ISE1RpAFwbKStO3q
    CJ43TkFHVOjuHrSB

    • Lift the speaker out of the rear case with the tip of a spudger.

    • Remove the rear case.

    It's not a speaker it the microphone and the wire is very fragile.

    Matt c -

    Hello. GoPro HERO2 there. overheating after doing update. 10-15 minutes after closing. overheating.

    coskunadnan -

    You can try put some new heat sink compound under that silver big element (radiator) that you see in step 9 (simply remove 2 screws holding it).

    hellfire -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

David Hodson

Member since: 14/04/10

148306 Reputation

0 comments