How to Reattach a Metal Rib to Fabric Panel on an Umbrella

Written By: Danielle Shapiro
  • Comments: 0
How to Reattach a Metal Rib to Fabric Panel on an Umbrella

Difficulty

Easy

Steps

7

Time Required

7 - 15 minutes

Introduction

Umbrellas help protect you from rain and other weather patterns and so it is important to keep them in working order. A detached metal rib can lead to issues with umbrella usage. This guide will help you reattach a metal rib to the fabric panel to get your umbrella back into working condition.

  1. bYtogSyyAod3DFBa

    • Open the umbrella and identify any metal ribs that have detached from the fabric panel.

  2. hfQHUQ5S3myNS1WR
    hfQHUQ5S3myNS1WR
    lMqoysUJOUxHIaYT

    • Tie a knot two inches from the end of the thread.

    • Place the opposite end of the thread into a sewing needle.

    • Rubbing or wetting the end of the thread may make it easier to insert the thread into the sewing needle.

  3. knEQihOQ1HUDWHnm

    • Align the metal rib with the region of the fabric panel that it detached from.

    • If necessary, use scotch tape to secure the metal rib into position so it does not lift up.

  4. OZEynErAAEGIlpf5
    OZEynErAAEGIlpf5
    kpJRXRuwJSW6FGYT
    jOoFVHECPfxaahFW

    • Be careful to avoid injury when using a sharp sewing needle.

    • Insert the sewing needle through the umbrella fabric panel and pull the thread through.

    • Poke the sewing needle through the underside of the fabric panel on the opposite side of the metal rib and pull the thread through.

  5. ROOGIHc2HrVZ5geK
    ROOGIHc2HrVZ5geK
    2xtTVGCRGW2KXWBT
    W14apIG4dFw1XOTW

    • Pull the sewing needle and thread across to wrap around the metal rib.

    • Insert the sewing needle through the fabric panel and pull the thread through.

    • Repeat Steps 4 and 5 until the metal rib is tightly secured to the fabric panel. Three additional loops is recommended.

  6. VqqW5qbXHHdIYogU
    VqqW5qbXHHdIYogU
    evV1T1uQjy6TI3MI
    o5OhrgKttY3jmX4X

    • Remove the thread from the sewing needle.

    • Tie the loose end of the string to the end of the string with the knot from Step 2.

  7. i4iHBNWCyiEhP5hi
    i4iHBNWCyiEhP5hi
    VGRbq2XWFqvQXbeK
    ZNDKRo4aS6UZxuMp

    • Don't run with scissors!

    • Use scissors to cut off any excess thread.

    • If necessary, remove any scotch tape pieces.

Conclusion

Repeat these steps if there are multiple detached metal ribs from the fabric panel. Once the repair is completed, the umbrella should work properly again.

Author

Danielle Shapiro

Member since: 19/02/20

148 Reputation

0 comments