Kodak Easyshare Z981 LCD Screen Replacement

Written By: Daniel Ramirez
  • Comments: 0
Kodak Easyshare Z981 LCD Screen Replacement

Difficulty

Moderate

Steps

7

Time Required

15 minutes

Introduction

  1. MgoBGV6CKSFRga1A
    MgoBGV6CKSFRga1A
    UTKW6uPEJAukoSsU

    • Open the battery cover and remove batteries from the camera if any are inserted.

  2. NeUObAIPpb2QVp62
    NeUObAIPpb2QVp62
    GeFdnpjVCUTOGQNU

    • Use a 00 Phillips-Head screwdriver to remove screws:

    • Remove the 3 mm screws from the camera

    • Four (4) screws are in the bottom of the device

    • Four (4) screws are inside the battery cover

  3. FsE1DeEBFFaQvQT6

    • Start from a corner and gently remove the cover.

    • The cover will easily lift off, so not much pressure is required.

    • Make sure to gently remove the bottom cover in order to avoid breaking the plastic.

  4. eKminhGGmZxorAYB
    eKminhGGmZxorAYB
    HgGScZoF4uxkWkPV

    • Use a Phillips #00 Screwdriver to remove the 4 mm screws from each side of the back cover of the camera.

    • Two (2) screws are located in the left side of the device

    • Two (2) screws are locatecd in the right side of the device

  5. XDh3VYtGOlodkICa
    XDh3VYtGOlodkICa
    Z1REvnQhZbdWpSmQ

    • Insert the Plastic Opening Tool in to the crevices of back cover and gently apply pressure

    • Be gentle while removing the cover, to avoid cracking the case

  6. xrATnLEAGGrhbJIQ
    xrATnLEAGGrhbJIQ
    QqEAFnqh3nWJvJKK

    • Once the back cover is removed locate the four 3mm screws holding the screen and the metal brace to the circuit board

  7. 1bMyBYQMOfgCxgtA
    1bMyBYQMOfgCxgtA
    l6WM5fVdaAbAcuJq
    2ZtnOAfTJ4y4aXIc

    • Gently lift up the metal brace and use a pair to disconnect the ribbon cable connecter

    • Use Tweezers to disconnect the ribbon cable connector.

    • Once disconnected remove the screen brace from the circuit board

    • Use extreme caution when removing the LCD brace pulling the brace may tear the cable

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Daniel Ramirez

Member since: 03/03/15

152 Reputation

0 comments