LG L1200 Logic Board Replacement

Written By: Joshua Herrmann
  • Comments: 0
LG L1200 Logic Board Replacement

Difficulty

Moderate

Steps

8

Time Required

15 minutes

Introduction

This guide will help you replace the logic board.

  1. D2ZHUPnLio2rGEjB

    • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

    • Poke out rubber covers using a spudger or pointy object, such as a thumb tack.

  2. JTnYBBH4en66LWLF

    • Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.

  3. 3kLnEWjKj36tjqhi

    • Use IPod opening tool to separate back housing.

    • There are two tabs located on either side of the phone.

  4. AGaMDTEOfFRCoajf

    • Separate the back housing from the phone.

    • Be careful not to rip out the wire (highlighted in yellow) when separating the back housing.

  5. ahTtffsmSWiPVQVR

    • Use a spudger to disconnect antenna wire.

  6. KEwaUt116WQtsxUI

    • Use the IPod opening tool to pop out the logic board.

  7. DC4Tgs1rxZUGUVlL

    • Use the IPod opening tool to disconnect the main ribbon.

  8. OenxXW6JoefgpWpZ

    • Once the ribbon is detached, remove the logic board and replace if necessary.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Joshua Herrmann

Member since: 16/04/10

8 Reputation

0 comments