Logitech MX Master 2s Mouse Feet Replacement

Written By: Alex Diaz-Kokaisl

Comments: 0

Logitech MX Master 2s Mouse Feet Replacement

Difficulty

Moderate

Steps

Time Required

10 - 20 minutes

Introduction

Use this guide to replace the feet (also called skates or pads) on your Logitech MX Master 2s.

Tools

Step 1

If you're planning to reuse your mouse feet, you'll need to thoroughly heat them for a clean removal.
Power off your mouse and turn it over.
Heat an iOpener and apply it to the bottom of the mouse for two minutes.
A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the mouse—the battery is susceptible to heat damage.

Step 2

Insert an opening pick between the mouse foot and the body.
Make sure the pick is underneath the foot and the adhesive layer. It's easy to separate these two layers.
Slide the pick under the foot to separate the adhesive.
If the pick feels stuck, apply more heat before continuing.

Step 3

Use tweezers, or your fingers, to remove the mouse foot.

Step 4

Repeat the previous two steps for the three remaining feet.

Step 5

During reassembly, remove any adhesive chunks and wipe away residue with a lint-free cloth and high-concentration isopropyl alcohol.

Conclusion

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow the above steps in reverse order.

Author

Alex Diaz-Kokaisl

Member since: 16/01/22

68841 Reputation