Mad Catz Street Fighter IV FightPad Buttons Replacement

Written By: Eric
  • Comments: 0
Mad Catz Street Fighter IV FightPad Buttons Replacement

Difficulty

Easy

Steps

9

Time Required

10 - 15 minutes

Introduction

Use this as a guide to remove or replace the controller's face buttons and shoulder buttons.

  1. pm416YSWvG5ucNwk

    • Use tweezers to completely remove the sticker from the rear of controller.

  2. 3uXvLlgQHkmtRRUM

    • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

  3. FumE6DnlEejBvJim
    FumE6DnlEejBvJim
    EOnKxbsxMUVWcPcp

    • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

    • Use the plastic opening tool to pry the two cases apart.

  4. VVEjO1MLOoycT6Qt
    VVEjO1MLOoycT6Qt
    IJqQCC1YUNNyCDK3

    • Remove the two rubber side grips.

  5. 6mf2FoIsZRtoAyTA
    6mf2FoIsZRtoAyTA
    unvODXCdUGvmTYGU

    • Locate RS-DP-LS switch.

    • Pull upwards on the switch to remove it.

  6. viIJjwUHe2BtVuuD

    • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

  7. hiophYM5WgcCxTmQ
    hiophYM5WgcCxTmQ
    s33OpVCF5QyrPnlp
    fJSaAKgMbFlQCEAW

    • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

    • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

    • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

  8. COJhI2BZBUIlteNR
    COJhI2BZBUIlteNR
    Dd1GrdRVNEcctWv5

    • Remove the six buttons one by one by gripping the back of each one and pushing on them from the front.

    • Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.

    • When reinserting the buttons make sure they are in the correct place and oriented correctly.

  9. LsHO2XAg6InClMyo

    • Remove the left and right shoulder buttons by sliding them out of their respective slots.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Eric

Member since: 26/09/12

117 Reputation

0 comments