Moto G4 Vibration Motor Replacement

Written By: Nathan Granger

Comments: 8

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

If your Motorola Moto G4 is no longer vibrating, replacing the part be necessary. This guide will show the right steps to replacing yourself!

Tools

Parts

Motorola Moto G4 Vibration Motor

Step 1

Insert a fingernail or a spudger into the notch on the bottom edge of the phone, near the charge port.
Gently twist or pry to open a small gap between the back cover and the body of the phone.
While keeping your tool (or fingernail) inserted into the gap between the back cover and the body of the phone, slide it around the corner to begin loosening the plastic clips holding the cover in place.

Step 2

Slide your tool all along the side of the phone to separate more of the clips securing the back cover.

Step 3

Keep your tool inserted slightly under the back cover, and slide it around the top corner.
If necessary, continue prying around the remaining edges of the phone until the back cover comes free.

Step 4

Remove the back cover.
To install the back cover, carefully position it over the phone and then press gently all around the edges until you feel the clips snap into place.

Step 5

Push to eject and remove the MicroSD and SIM cards (if installed).

Step 6

Use a spudger to pry up the rubber cover for the camera flash connector.

Step 8

Use a spudger to disconnect the camera flash connector by prying it straight up.

Step 9

Use a T3 Torx driver to remove the nineteen identical 3.1 mm screws securing the midframe.

In my kit, the T3 Torx bit came in the ‘repair part’ box, while a T5 Torx bit was in the ‘repair tools’ box.

Joseph Albert - 06/09/18

my phone had t4, not t3

Donald Smith - 30/07/19

Screws are stuck quite hard, apply a hefty amount of pressure when removing. Otherwise you’ll destroy the thread

face - 27/11/19

unable to remove 8 of the screws. any suggestions?

wayne malcom - 15/02/20

My T4 is the tool that fit. I can see why people strip these. They were dam tight for such little screws.

I also had a tough time getting them out of the socket once loose. Magnet in the tool was not very strong. I used my tweezers, and scratch the screw heads. That means they are real soft steel, and strip easy.

P 38 -

Step 10

Insert a spudger under the midframe at the top left corner, and gently twist to separate it from the body of the phone.

I couldn’t get the spudger in, but had success with the opening pick instead.

Bernd Mast - 07/06/21

Step 11

Remove the midframe.

During the midframe removal, be careful and do not put too much torsional stress on the loudspeaker pickup wires (to the right of the main camera). It’s not that difficult to crush or shear the pickups there. Doing so will render your phone silent.

Kevin Kwan - 10/12/18

Exactly what happened to me. Both contacts broke off and if just loosely put where they were, they can't make proper contact anymore.

There should be a warning about this in the guide itself!

Simon Vetter - 24/12/19

Step 12

Insert a thin tool (such as one of your tweezer tips) under the red and black battery wires, and slide it underneath the battery connector.
Gently pry straight up to disconnect the battery.
Pry only from the side where the wires attach to the connector—if you pry anywhere else, you may break the socket.
During reassembly, align the connector in its socket and then press straight down to reconnect it, wiggling slightly as you press to help it seat correctly.