Introduction
Use this guide to replace the power board on your Nintendo Wii mini.
-
-
Remove the two rubber feet at the back of the console to reveal the hidden screws.
-
Remove the four 6mm Phillips #0 screws.
-
-
-
Turn the Wii mini right-side up. Then run a plastic opening tool around the middle edge of the console to loosen the top piece.
-
Gently lift the top piece of the console and set it aside.
-
-
-
Using your fingers, slide out the blue ribbon cable from the the top of the power board.
-
Using a Phillips #0 Screwdriver, unscrew the two 4mm screws at the top and bottom of the power board.
-
-
-
Using your fingers, gently pull the pin connector to disconnect the power board from the disc drive.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
