Introduction
The housing of the 05000A is attached with a few screws and can be opened easily.
-
-
Remove two Phillips screws at the top.
-
Remove four Phillips screws from the back panel. They are very deep and you need a screwdriver with a very long shaft.
-
Remove three Phillips screws from the bottom of the back panel
-
-
-
Unscrew the two Phillips screws on both sides of the back.
-
Then pull the back part backwards. Watch out for the power cord.
-
-
-
Open the front door.
-
The front part is still attached with two Phillips screws. turn them out.
-
-
-
The front part now only hangs with cables on the connection buttons of the control panel. In order to get better access to the brew group or the grinder, it is sufficient to push the front part forward about 10 cm. If that's not enough, you have to free the control panel.
-
Work the steps in reverse order to reassemble your device.
