Rowenta Focus Power Assembly Replacement

Written By: Nikhil Salian
  • Comments: 0
Rowenta Focus Power Assembly Replacement

Difficulty

Easy

Steps

5

Time Required

10 - 20 minutes

Introduction

This guide will provide a step-by-step walkthrough on how to replace the power assembly of a Rowenta Focus DW5080. This is useful for troubleshooting a faulty power cord and allowing the iron to have power again. This part should only be replaced if the outlet the cord was plugged into has been checked and works. The light on the iron should not be on and the iron should not be getting warm if this part is damaged.

Prior to beginning this repair, be sure the device is turned off and unplugged.

  1. pqRQFXltZeGmNP6R
    pqRQFXltZeGmNP6R
    jffr2FAwuQSrpYHx

    • Using a T20 screwdriver, remove the 20 mm screw on the back of the iron.

    • Unplug iron before removing cover and make sure the iron is cool before beginning the repair.

  2. J3S1BwAIpZCF5cMa
    J3S1BwAIpZCF5cMa
    ULTRwYZlVUA2EpaP
    EDYKjGmYS2iFBvDC

    • Pry the back cover of the iron off using a metal spudger.

    • Remove the back cover, exposing the wiring in the iron.

  3. jXBqjB4LSrKKClap
    jXBqjB4LSrKKClap
    VA5pCrBkskylsQYE

    • Remove the frontmost (main) power cord to give access to inner wiring and accessories.

    • Leave the other cords attached to the main cord.

  4. YtEVmOfVgQURUAaj
    YtEVmOfVgQURUAaj
    fiRmNIRdiTEIMAaE

    • Pull out the motherboard inside handle of iron.

    • Keep it attached to main power cord and other components.

  5. pCl6Ou2LVq3V5EQw
    pCl6Ou2LVq3V5EQw
    NSpnoFbMHgi3uDvU
    sCjWiHWS2VsIaFto

    • Remove the 4-pronged adaptor from inside the iron by grabbing the black plastic piece and pulling straight out.

Conclusion

To reassemble your device with new power supply, follow these instructions in reverse order.

Author

Nikhil Salian

Member since: 03/09/21

216 Reputation

0 comments