Samsung Galaxy Watch Active2 Back Cover Replacement

Written By: Tobias Isakeit

Comments: 9

Samsung Galaxy Watch Active2 Back Cover Replacement

Difficulty

Moderate

Steps

Time Required

20 - 30 minutes

Introduction

Use this guide to replace a defective back cover of your Samsung Galaxy Watch Active2. You can also use this guide to open your smartwatch for any other repair.

Tools

Step 1

Turn off the Galaxy Watch Active2 by pushing and holding the bottom button for approximately 3 seconds. You should feel a short vibration.
When the "Power off" symbol appears, tap the center of the screen to make it shut down. You should feel a longer vibration for confirmation.

Step 2

Use a Tri-point Y00 screwdriver to remove the four 4 mm-long screws on the back of the watch.

Y1.5 works just as good

BRIAN MIRANDA -

Step 3

Use an opening pick and place it between the plastic back cover and the metal housing near the buttons.
Push the opening pick into the gap to separate the back cover from the housing.
Don’t remove the back cover all the way yet. There is a cable connecting it to the motherboard.

There is a glue-ish gasket keeping it closed. I used an exacto knife to start it opening.

BRIAN MIRANDA -

This was super helpful thank you! Perfect timing

this is trash -

Waarmee kan ik de achterste oplaadplaat weer vast lijmen op de achterste behuizing

Ilona Smit -

Step 4

Carefully lift the back cover to access the sensor array connector.
Use a spudger to disconnect the sensor array from the motherboard.

Ou je peu me procurer le tourne vis tri point 000

grenierlulu -

Step 5

Remove the back cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

4 comments

What kind of glue would you use if the plastic of the back cover fell off?

Dave Hains -

Hello. Where can i get the back cover with adhesive as a replacement or just the adhesvie? I noticed it is a weird rubbery glue and i cannot source this anywhere.

Arbuzov Paul -

What kind of glue would you use if the plastic of the back cover fell off