Shark Vertex Pro IZ682H Brush Roller Belt Replacement

Written By: Tyree Brooks
  • Comments: 0
Shark Vertex Pro IZ682H Brush Roller Belt Replacement

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

This guide will show you how to replace the brush roller motor belt on the power nozzle of the Shark IZ682H.

  1. hW6t5adMRSUKiTMI

    • Detach the power nozzle from the vacuum and turn it so the right side is facing you. Pull down the blue tab to the direction where the arrow is facing.

    • The brush roller should now pop out.

    • Putting the brush roller in again does not require pulling the blue tab. It should pop in with no problem.

  2. xcObgOCTRwD6p4YR

    • Turn the three plastic locks to the unlocked position and remove the crevice tool.

    • Use T9 and T15 screwdrivers to remove the seven screws.

  3. TofDJIMNN3wrnArG
    TofDJIMNN3wrnArG
    eH1heKpCEJhoqwKn

    • Use an opening tool on the edges of the casing and pull off the thin plastic coverings on both sides.

    • Expect to hear snapping noises.

    • Pull the plastic coverings off the powerhead.

  4. XjmvrBwTmTHYURjY

    • Remove the six screws using a T15 Torx security screwdriver.

    • Remove the plastic headcover.

  5. MxLaxcZZpP2IE1HR

    • Remove the seven screws using the T10 and T15 Torx security screwdriver.

    • Lift the covering and motor assembly enough to see the belt.

  6. eQyMeiAlVZhx6NGH

    • Remove the belt and power nozzle.

    • When reinstalling, be sure the belt is tightly secured around the gear grooves.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tyree Brooks

Member since: 26/10/22

483 Reputation

0 comments