Vornado Duo Circuit Board Replacement

Written By: Tyler Pettenger

Difficulty

Moderate

Steps

Time Required

9 - 10 minutes

Introduction

In this replacement guide, step by step instructions will show how to replace the circuit board located inside of the Vornado Duo.

Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.

Remove fan blade after unscrewing top 2 screws located on each side of the covered board.

Unsolder the circled spots on the mother board and resolder each wire to corresponding spot.

And if not get the circuit board. how can you connect the wires direct.

I can't get the circuit board anywhere .so please help with the combined of the wires.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Member since: 28/09/17

536 Reputation