Xiaomi Mi 8 Rear Glass Replacement

Written By: Dominik Schnabelrauch

Comments: 3

Difficulty

Moderate

Steps

Time Required

20 - 35 minutes

Introduction

Use this guide to remove or replace the rear glass of the Xiaomi Mi 8.

You’ll need replacement adhesive to reattach components when reassembling the device.

Tools

Step 1

Apply a heated iOpener to the rear glass to loosen the adhesive beneath the edges. Apply the iOpener for at least two minutes.

Step 2

Secure a suction handle to the lower edge of the rear glass, as close to the edge as possible.
If the phone's rear glass is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.
Lift the rear glass with the suction handle to create a gap between the glass and the frame.
Insert an opening pick into the gap.
If the glass wont budge, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.
Slide the opening pick to the bottom right corner of the phone.

Step 3

Insert a second opening pick and slide it to the bottom left corner to cut the adhesive.
Leave the opening picks in place to prevent the adhesive from resealing.

Step 4

Insert a third opening pick at the bottom left corner.
Start to slide the opening pick from the bottom left corner along the side of the Xiaomi Mi 8 to cut the adhesive.
Be aware of the fingerprint flex cable and only insert the tip of the opening pick. If insert to deep, you can cut the cable by accident.
As the adhesive cools down it gets harder to cut. If necessary use your iOpener to reheat it.
Leave the opening pick in the top left corner to prevent the adhesive from resealing.

The back cover of MI 8 easily breaks while sliding the opening pick because it is made of fragile glass. Before sliding the pick, rim of the back cover should be heated enough to make adhesive loose.

Shunsuke Abe - 06/06/21

Step 5

Insert a fourth opening pick under the top left corner of the rear glass.
Slide the opening pick along the top to cut the adhesive.
Leave the opening pick in the top right corner to prevent the adhesive from resealing.

Step 6

Insert a fifth opening pick at the top right corner of the phone.
Slide the opening pick along the right edge to cut the remaining adhesive.
Don't try to remove the rear glass all the way yet. The fingerprint flex cable is still connected to the motherboard.

Step 7

Carefully lift the rear glass and fold it to the left side to access the fingerprint flex connector.

Step 8

Use a spudger to pry up and disconnect the fingerprint flex cable.
Remove the rear glass.
Before installing new adhesive for reassembly, remove any remaining adhesive from the phone, and clean the glued areas with isopropyl alcohol and a lint-free cloth.
After installing the rear glass, apply pressure for several minutes to help the adhesive form a good bond. A stack of heavy books on top of the phone works well.

Conclusion

Secure the new back cover with pre-cut adhesive or double-sided adhesive tape.

To reassemble your device, follow these instructions in reverse order.

After installing the rear glass, apply pressure for several minutes to help the adhesive form a good bond, such as by placing it under a stack of heavy books.

Repair didn’t go as planned? Check out our Answers Community for troubleshooting help.

Author

Dominik Schnabelrauch

Member since: 23/11/16

167372 Reputation

2 comments

what adhesive can you use to glue the back on and the fingerprint scanner to the back?

Polly -

Hi Polly,

you can either buy pre-cut adhesive for your device/rear glass or use thin double sided adhesive tape you cut by yourself. For example you can use this tesa adhesive card.

Dominik Schnabelrauch -