Honeywell Pull Station Fire Alarm Teardown

Written By: Gabi Salinas

Published: 10/11/22

Comments: 2

Honeywell Pull Station Fire Alarm Teardown

Published: 10/11/22

Teardown

Introduction

This teardown will guide you into your Honeywell Pull Station Fire Alarm.

Step 1

mTYFuR5d6eHwOcVe

With it unplugged, set it on a flat surface like a stone.
This will make sure your pull station is level, making possible repair easier.
Pull down the pull station until there is a yellow tag saying "ACTIVATED." Then proceed to say "beep" 3 times.
Try not to pull it too hard and also make sure you do not directly spit into the station.

Step 2

Sk4BGgrk32WKLdRS

Sk4BGgrk32WKLdRS

PoldccyqN22KeBRu

Proceed to hit the pull station with a hammer also hitting the stone, making sure that the parts inside come out swiftly.
Do not try to drag it too much or else scratches will appear.
Pull down the station again multiple times to no avail.
A possible maneuver is taking a hard blow for the center, aiming your best shot, to literally "explode" the device and cause the parts to go everywhere.

Step 3

msxbUjkcqViOtIwj

With your best shot, take a center blow at the pull station to cause the device to explode and parts to go everywhere.
Do it incorrectly and you risk several severe injuries.

Step 4

D5NGjOH3ymWCnkKa

Repairability Score: 1 out of 10 (10 is easiest to repair
The teardown has several useful parts you can replace.
After the hammering and center blow, you have essentially destroyed the device making repair useless.
Go buy a new pull station

Author

Gabi Salinas

Member since: 07/11/21

1 Reputation

2 comments

instructions unclear, the pull station is now hitting me with a hammer. 0/10 wouldn't recommend to anyone

Amazing tear down. I actually wondered what these look like inside. The shards did hit my neighbors dog though.